Influence of micro-EDM-induced surface modifications on the sequential micro-grinding performance of SiC
Authors:
- Anang KatyayanAKAnang Katyayan
- Probir SahaPSProbir Saha
- Afzaal AhmedAAAfzaal Ahmed
- 31 March 2026
- journal article
- Published by Elsevier in CIRP Journal of Manufacturing Science and Technology
- Vol. 67, 206-220
Abstract
No abstract availableFunding Information
- Anusandhan National Research Foundation
This publication has 36 references indexed in Scilit:
- Research on micro-grinding performance of 2.5D Cf/SiC compositesThe International Journal of Advanced Manufacturing Technology, 2024
- Experimental analysis of ductile-brittle transitions for parallel and intersecting micro-slot grinding in BK-7 glassCeramics International, 2019
- Effect of minimum quantity lubrication on surface integrity in high-speed grinding of sintered alumina using single layer diamond grinding wheelCeramics International, 2018
- Burr formation mechanism of ultraprecision cutting for microgrooves on nickel phosphide in consideration of the diamond tool edge radiusThe International Journal of Advanced Manufacturing Technology, 2017
- Experimental investigation into the micro-EDM characteristics of conductive SiCCeramics International, 2016
- Evaluation of μEDM-drilling and μEDM-dressing performances based on online monitoring of discharge gap conditionsThe International Journal of Advanced Manufacturing Technology, 2015
- Sintered diamond as a hybrid EDM and grinding tool for the micromachining of single-crystal SiCCIRP Annals, 2015
- Hybrid processes in manufacturingCIRP Annals, 2014
- Fabrication of different geometry cutting tools and their effect on the vertical micro-grinding of BK7 glassThe International Journal of Advanced Manufacturing Technology, 2011
- Ductile-regime turning mechanism of single-crystal siliconPrecision Engineering, 1996