Voltage–current characteristics of high-current glow discharges
Authors:
Open Access
- 25 April 2001
- journal article
- conference paper
- Published by AIP Publishing in Applied Physics Letters
- Vol. 78 (18) , 2646-2648
Abstract
The voltage–current characteristics of glow discharges in gas mixture at a pressure of 10 Torr were obtained with the discharge current up to 150 A. Parallel-plane electrodes with a diameter of 10.7 cm and a discharge chamber with co-axial geometry were used to produce glow discharge with high current. The glow discharge voltage was almost constant until the whole surface of the cathode was covered with glow, i.e., until the discharge current became 3.7 A in our experimental condition (a normal glow discharge mode). The voltage, however, increased with the current when the glow covered over the cathode (an abnormal glow discharge mode). The electron density in positive column of the high-current glow discharge was obtained to be from Langmuir probe measurements.
Keywords
This publication has 9 references indexed in Scilit:
- Influence of a ground shield on heat flux in parallel-plate plasma systemJournal of Physics D: Applied Physics, 2000
- Flexible microdischarge arrays: Metal/polymer devicesApplied Physics Letters, 2000
- Characteristics of a high-current transient glow discharge in dry airJournal of Physics D: Applied Physics, 2000
- Fused hollow cathode cold atmospheric plasmaApplied Physics Letters, 2000
- An atmospheric pressure plasma sourceApplied Physics Letters, 2000
- High-pressure hollow cathode dischargesPlasma Sources Science and Technology, 1997
- Current-voltage characteristics of a high-current pulsed discharge in airIEEE Transactions on Plasma Science, 1988
- V-I characteristics of pulsed CO2 laser dischargesApplied Physics Letters, 1973
- The Development of Spark Discharges in HydrogenAustralian Journal of Physics, 1969