Deformation Size Effects Due to Specimen and Grain Size in Microbending
Authors:
- 1 February 2010
- journal article
- Published by ASME International in Journal of Manufacturing Science and Engineering
- Vol. 132 (1) , 011018
Abstract
Sheet metal forming often consists of bending processes in which gradients of deformation exists through the thickness of the workpiece in a localized deformation area. In microscale bending, these deformation gradients become much steeper, as the changes in the deformation occur over short distances (in the order of micrometers). In addition, with miniaturization, the number of grains that are present through the thickness decreases significantly. In this research, the effect of grain size and specimen size on the deformation distribution through the thickness of microbent sheet specimens was investigated via microhardness evaluations. It was found that the deformation distribution, i.e., hardness profile, is not affected significantly by the grain size when the sheet thickness is large (for 1.625 mm specimens) or by miniaturization of the specimen size when the grain size is fine. However, the deformation distribution of the coarse grained specimens deviates from the fine grained ones and from the 1.625 mm thick sheet specimens when the specimen size is miniaturized.Keywords
This publication has 8 references indexed in Scilit:
- Springback behavior of brass in micro sheet formingJournal of Materials Processing Technology, 2007
- Size effects from grain statistics in ultra-thin metal sheetsJournal of Materials Processing Technology, 2006
- Microforming: Experimental Investigation of the Extrusion Process for Micropins and its Numerical Simulation Using RKEMJournal of Manufacturing Science and Engineering, 2004
- State of the art in micro forming and investigations into micro deep drawingJournal of Materials Processing Technology, 2004
- Microforming—from basic research to its realizationJournal of Materials Processing Technology, 2002
- Size effects in the processing of thin metal sheetsJournal of Materials Processing Technology, 2001
- MicroformingCIRP Annals, 2001
- Miniaturization in sheet metal workingJournal of Materials Processing Technology, 2000