An exergetic performance assessment of three different food driers
Authors:
Open Access
- 8 September 2009
- journal article
- research article
- Published by SAGE Publications in Proceedings of the Institution of Mechanical Engineers, Part A: Journal of Power and Energy
- Vol. 224 (1) , 1-12
Abstract
In this study, plum slices were dried in three different driers (tray, fluid bed, and heat pump (HP) driers). Drying experiments were carried out at an air temperature range of 45-55 °C with an air velocity of 1.5 m/s. The performance of the driers along with their main components was evaluated and compared by using the exergy analysis method. The most important component for improving the system efficiency was determined to be the fan—heater combination for both the tray and fluid bed driers, and the motor—compressor assembly for the HP drier. The exergy loss and flow diagram (the so-called Grassmann diagram) of the driers was also presented to give quantitative information regarding the proportion of the exergy input dissipated in the various system components. Effects of the drying air temperature on the performance of the drying process were discussed. The highest exergetic efficiency values were obtained to range from 72.72 to 75.66 per cent for the HP drier, followed by the tray and fluid bed driers varying between 37.94 and 39.46 per cent, and between 22.83 and 24.07 per cent, respectively.Keywords
This publication has 40 references indexed in Scilit:
- THIN‐LAYER DRYING BEHAVIORS OF OLIVE LEAVES (OLEA EUROPAEA L.)Journal of Food Process Engineering, 2010
- A review of gas engine driven heat pumps (GEHPs) for residential and industrial applicationsRenewable and Sustainable Energy Reviews, 2009
- Performance of a heat pump drier for copra dryingProceedings of the Institution of Mechanical Engineers, Part A: Journal of Power and Energy, 2008
- EXERGETIC ASSESSMENT OF DRYING OF MINT LEAVES IN A HEAT PUMP DRYERJournal of Food Process Engineering, 2008
- Thin layer drying model for treated and untreated Stanley plumsEnergy Conversion and Management, 2006
- Energy and exergy of potato drying process via cyclone type dryerEnergy Conversion and Management, 2005
- Analysis on the heating performance of a gas engine driven air to water heat pump based on a steady-state modelEnergy Conversion and Management, 2005
- A new model for thermodynamic analysis of a drying processInternational Journal of Heat and Mass Transfer, 2004
- Calculation for physical and chemical exergy of flows in systems elaborating mixed-phase flows and a case study in an IRSOFC plantInternational Journal of Energy Research, 2003
- Mathematical Model for Exergy Analysis for Drying PlantsDrying Technology, 1995