Optimization of Machining Condition in WEDM for Titanium Grade 6 Using MOORA Coupled with PCA — A Multivariate Hybrid Approach
- 5 June 2017
- journal article
- Published by World Scientific Pub Co Pte Ltd in Journal of Advanced Manufacturing Systems
- Vol. 16 (02) , 81-99
Abstract
This paper represents a multivariate hybrid approach, combining Multi-Objective Optimization on the basis of Ratio Analysis (MOORA) and Principal Component Analysis (PCA) to optimize different correlated responses during Wire Electrical Discharge Machining (WEDM) process of titanium grade 6. The response parameters selected are the average cutting speed, average Kerf width and average surface roughness (Ra). All of them have been studied in terms of pulse-ON time, pulse-OFF time, wire feed and wire tension. As indicated by Taguchi’s signal-to-noise ratio, the optimum process parameters were achieved for the desired average cutting speed, average Kerf width and average surface roughness, respectively. At last, the optimum combination of process parameters was validated by affirmation test which gave considerably improved various quality characteristics. Confirmation test outcome revealed that multivariate hybrid approach MOORA coupled with PCA was a competent strategy to decide available cutting parameters for a desired response quality for WEDM of titanium grade 6.Keywords
This publication has 39 references indexed in Scilit:
- Modeling and Analysis on the Influence of Reinforcement Particle Size During EDM of Aluminum (Al/3.25Cu/8.5Si)/Fly Ash CompositesJournal of Advanced Manufacturing Systems, 2016
- Multi Criteria Selection of Optimal Machining Parameter in Turning Operation Using Comprehensive Grey Complex Proportional Assessment Method for ASTM A36International Journal of Engineering Research in Africa, 2016
- Application of MCDM-Based TOPSIS Method for the Optimization of Multi Quality Characteristics of Modern Manufacturing ProcessesInternational Journal of Engineering Research in Africa, 2016
- A study on the ranking performance of some MCDM methods for industrial robot selection problemsInternational Journal of Industrial Engineering Computations, 2016
- Analysis of the influence of EDM parameters on surface finish, material removal rate, and electrode wear of an INCONEL 600 alloyThe International Journal of Advanced Manufacturing Technology, 2015
- Experimental investigation and multi-objective optimization of wire electrical discharge machining (WEDM) of 5083 aluminum alloyTransactions of Nonferrous Metals Society of China, 2014
- Experimental investigation, intelligent modeling and multi-characteristics optimization of dry WEDM process of Al–SiC metal matrix compositeJournal of Manufacturing Processes, 2013
- Multi-response optimization of process parameters based on response surface methodology for pure titanium using WEDM processThe International Journal of Advanced Manufacturing Technology, 2013
- Electrical discharge machining of ceramic/semiconductor/metal nanocompositesScripta Materialia, 2010
- Advancing EDM through Fundamental Insight into the ProcessCIRP Annals, 2005