Effect of cooling methods on hole quality in drilling of aluminium 6061-6T
Authors:
Open Access
- 1 February 2016
- conference paper
- Published by IOP Publishing in IOP Conference Series: Materials Science and Engineering
- Vol. 114 (1) , 012022
Abstract
The influence of cooling method and drilling parameters on hole production has been investigated experimentally and analytically by measuring the hole quality. A three-level, three-parameter experiment was conducted using design-of-experiment methodology. The three levels of independent input parameters were: for cooling method-flood drilling, minimum quantity lubrication (MQL) drilling and cryogenic drilling; for feed rate-0.2, 0.3 and 0.4 mm/rev; and for cutting speed-60, 75 and 100 m/min. The selected work and tool materials were aluminium 6061-6T and high speed steel (HSS), respectively. The measured output parameters were the three most widely used quality characteristics of drilled holesdiameter error, circularity and surface roughness. The results were analysed applying three methods: Pareto ANOVA, Taguchi method and traditional analysis. The findings revealed that the cooling method has a significant effect on diameter error (contribution ratio 88.27%), moderate effect on surface roughness (contribution ratio 41.74%) and relatively small effect on circularity (contribution ratio 23.64%). The best results for the dimensional accuracy and surface roughness were achieved by MQL drilling. Cryogenic drilling produced the best circularity results; however, in terms of dimensional accuracy and surface roughness it was the worst.Keywords
This publication has 17 references indexed in Scilit:
- Optimization of drilling parameters using Taguchi technique and response surface methodology (RSM) in drilling of AISI 304 steel with cryogenically treated HSS drillsJournal of Intelligent Manufacturing, 2013
- Taguchi method based optimisation of drilling parameters in drilling of AISI 316 steel with PVD monolayer and multilayer coated HSS drillsMeasurement, 2012
- Evaluation of thrust force and surface roughness in drilling composite material using Taguchi analysis and neural networkJournal of Materials Processing Technology, 2008
- Application of Taguchi methods in the optimization of cutting parameters for surface finish and hole diameter accuracy in dry drilling processesThe International Journal of Advanced Manufacturing Technology, 2008
- Drilling carbon fiber reinforced plastics manufactured by autoclave—experimental and statistical studyMaterials & Design (1980-2015), 2003
- Using a minimum quantity of lubricant (MQL) and a diamond coated tool in the drilling of aluminum–silicon alloysJournal of Materials Processing Technology, 2002
- Experimental investigation of the effect of drill coatings on hole quality under dry and wet drilling conditionsSurface and Coatings Technology, 2001
- Cutting performance of different coated twist drillsJournal of Materials Processing Technology, 1999
- Estimation of Cutting Temperature in High Speed MachiningJournal of Engineering Materials and Technology, 1992
- Investigations on reducing burr formation in drillingInternational Journal of Machine Tool Design and Research, 1986