Adiabatic remelting of the mushy-zone during rapid solidification
Authors:
- 21 August 2006
- journal article
- research article
- Published by Taylor & Francis in Philosophical Magazine
- Vol. 86 (24) , 3795-3807
Abstract
In two-step solidification of alloys that form a metastable phase, the first stage of microstructural evolution following solidification of the primary (metastable) phase involves growth of the stable phase into the mushy-zone. The growth rate of the stable phase can be predicted using a simple dendrite growth model if the heat balance is modified to include isothermal melting of the pre-existing solid. This adiabatic remelting model successfully predicts the growth rates for the stable phase as measured experimentally in the Fe–Cr–Ni alloy system. The growth rate of the stable phase depends strongly on composition, but this dependence is countered by a reduction in the heat absorbed through melting of the metastable solid. Due to the small variation in thermophysical properties over a wide range of compositions, the net result of these two competing effects is a heat flux, which is proportional to the thermodynamic driving force.Keywords
This publication has 7 references indexed in Scilit:
- Growth Competition During Double Recalescence in Fe-Cr-Ni AlloysMRS Proceedings, 1998
- OBSERVATION OF PHASE SELECTION FROM DENDRITE GROWTH IN UNDERCOOLED Fe-Ni-Cr MELTSActa Materialia, 1997
- Nucleation and phase selection in undercooled Fe-Cr-Ni melts: Part II. Containerless solidification experimentsMetallurgical and Materials Transactions A, 1997
- Solidification of undercooled Fe-Cr-Ni alloys: Part II. Microstructural evolutionMetallurgical and Materials Transactions A, 1996
- Solidification of undercooled Fe-Cr-Ni alloys: Part I. Thermal behaviorMetallurgical and Materials Transactions A, 1995
- Effect of growth rate dependent partition coefficient on the dendritic growth in undercooled meltsActa Metallurgica, 1987
- Rapid dendrite growth in undercooled alloysActa Metallurgica, 1987