Top-Seeded Solution Growth of 4H-SiC Bulk Crystal Using Si-Cr Based Melt
Authors:
- 14 May 2012
- journal article
- Published by Trans Tech Publications, Ltd. in Materials Science Forum
- Vol. 717-720, 61-64
Abstract
We have grown high-quality long cylindrical (12 mm thick) 4H-SiC bulk crystals by the meniscus formation technique, which was first applied for the solution growth of bulk SiC. It enabled long-term growth by suppressing parasitic reactions such as polycrystal precipitation around the seed crystal. In addition, we could control the growth angle from −22° to 61° by adjusting the meniscus height. The thickness of the grown cylindrical crystals was 12 mm, which is the largest reported until now, and corresponded to a growth rate of 0.6 mm/h. Smooth morphology growth was maintained on the (000-1) C-face. In cross-sectional transmission optical microscopy images, few solvent inclusions and voids were observed. XRD measurements revealed that the FWHM values of the grown crystals were almost the same as those of the seed crystal.Keywords
This publication has 6 references indexed in Scilit:
- Solution Growth and Crystallinity Characterization of Bulk 6H-SiCMaterials Science Forum, 2010
- High-Speed Growth of High-Quality 4H-SiC Bulk by Solution Growth Using Si-Cr Based MeltMaterials Science Forum, 2010
- Historical overview of silicon crystal pulling developmentMaterials Science and Engineering: B, 2000
- Influence of surface energy on the growth of 6H- and 4H-SiC polytypes by sublimationMaterials Science and Engineering: B, 1992
- Growth of silicon carbide from liquid silicon by a travelling heater methodJournal of Crystal Growth, 1973
- Flux growth of large crystals by accelerated crucible-rotation techniqueJournal of Crystal Growth, 1971