A Low-EMI Buck Converter Suitable for Wireless Sensor Networks With Spur-Reduction Techniques
Authors:
- 17 December 2015
- journal article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Sensors Journal
- Vol. 16 (8) , 2588-2597
Abstract
This paper presents a low electromagnetic interference buck converter for wireless sensor networks with the spur-reduction techniques. The proposed buck converter uses the third-order delta-sigma modulator (DSM) with its noise-shaping characteristic to achieve low output noise. The DSM is designed with the chopper-stabilization techniques, which further reduces the impacts of low-frequency noises, such as flicker noise and offset voltage. The proposed buck converter also adopts fast transient path in order to get a fast transient response. The proposed buck converter has been fabricated with a TSMC 0.35-μm CMOS 2P4M process. The area of the whole chip is 2.18 mm 2 . Compared with previous works, the noise floor of the proposed converter's output is below -76 dBm, which is lower than others. The settling time of the proposed converter's output is ~20 μs with the load current skipping between 50 and 500 mA, that is faster than previous works, too. Moreover, the peak efficiency of the proposed converter is better and equals to 90%.Keywords
Funding Information
- Ministry of Science and Technology within the Chip Implementation Center for fabricating the IC Chip
This publication has 19 references indexed in Scilit:
- A Spurious-Free Switching Buck Converter Achieving Enhanced Light-Load Efficiency by Using a $\Delta \Sigma$-Modulator Controller With a Scalable Sampling FrequencyIEEE Journal of Solid-State Circuits, 2012
- A Noise-Shaped Buck DC–DC Converter With Improved Light-Load Efficiency and Fast Transient ResponseIEEE Transactions on Power Electronics, 2011
- Adaptive Digital Controller and Design Considerations for a Variable Switching Frequency Voltage RegulatorIEEE Transactions on Power Electronics, 2009
- A Low-Offset Low-Noise Sigma-Delta Modulator With Pseudorandom Chopper-Stabilization TechniqueIEEE Transactions on Circuits and Systems I: Regular Papers, 2009
- A fast-transient over-sampled delta-sigma adaptive DC-DC converter for power-efficient noise-sensitive devices2007
- A Noise-Shaped Switching Power Supply Using a Delta–Sigma ModulatorIEEE Transactions on Circuits and Systems I: Regular Papers, 2004
- A Low Voltage, Dynamic, Noninverting, Synchronous Buck-Boost Converter for Portable ApplicationsIEEE Transactions on Power Electronics, 2004
- A comprehensive power analysis and a highly efficient, mode-hopping DC-DC converter2003
- Use of sigma-delta modulation to control EMI from switch-mode power suppliesIEEE Transactions on Industrial Electronics, 2001
- Circuit techniques for reducing the effects of op-amp imperfections: autozeroing, correlated double sampling, and chopper stabilizationProceedings of the IEEE, 1996