Tritium burn efficiency in deuterium–tritium magnetic fusion
Open Access
- 25 September 2023
- journal article
- research article
- Published by IOP Publishing in Nuclear Fusion
- Vol. 63 (12) , 126019
Abstract
The controlling parameters regarding tritium burn efficiency (TBE) are derived from first principles and shown to depend fundamentally on the permitted He gas fraction in the divertor and effective pumping speeds of He ash and unburned hydrogenic fuel. The analysis is generic to any equilibrated magnet fusion plasma using a divertor for particle exhaust. The He gas fraction in the plasma limits the maximum TBE due to the link between ash dilution effects in the core plasma and fusion performance. High TBE in magnetic fusion devices is counter-correlated to achieving high gain and power density for commercial fusion. The impact of TBE on fusion performance for several figures of merit are derived, including power density, required n − τ e product, and plasma energy gain Q p . The TBE formulation presented here is applied to existing devices, based on published data of enrichment and τ He ∗ from research tokamaks. This assessment strongly motivates exploration of technologies that would enhance the effective pumping speed of He to fuel out of the plasma.Keywords
This publication has 13 references indexed in Scilit:
- Progress toward fusion energy breakeven and gain as measured against the Lawson criterionPhysics of Plasmas, 2022
- Physics and technology considerations for the deuterium–tritium fuel cycle and conditions for tritium fuel self sufficiencyNuclear Fusion, 2020
- Divertor heat flux challenge and mitigation in SPARCJournal of Plasma Physics, 2020
- A New Concept for a Higher Burn-Up Fraction Improvement in DEMO ReactorIEEE Transactions on Plasma Science, 2018
- Tritium resources available for fusion reactorsNuclear Fusion, 2017
- Status and physics basis of the ITER divertorPhysica Scripta, 2009
- Helium and neon enrichment studies in the JET Mark IIAP and Mark IIGB divertorsNuclear Fusion, 2002
- Helium exhaust in ELMy H-mode plasmas with W-shaped pumped divertor of JT-60UJournal of Nuclear Materials, 1999
- Impurity enrichment studies with induced scrape-off layer flow on DIII-DNuclear Fusion, 1998
- Burn condition, helium particle confinement and exhaust efficiencyNuclear Fusion, 1990