Investigation of Electrically Heated Exploding Foils in Reactive Al/Ni Multilayer
- 1 August 2018
- journal article
- research article
- Published by Wiley in Propellants, Explosives, Pyrotechnics
- Vol. 43 (9) , 923-928
Abstract
The mechanisms of metal phase transition process during electrical explosion are experimentally and theoretically investigated. Past experiments of investigation are single metal foil, such as gold, aluminum, and copper. The characteristics of aluminum‐nickel (Al/Ni) multilayer foil were investigated, which means electrical behavior and energy output. The foil was fabricated by magnetron sputtering based on ceramic substrate, and lithographically patterned into bow‐tie bridge regions. Scanning electron microscopy characterization revealed the layer structure of the Al/Ni multilayer. X‐ray diffraction characterization was employed to ascertain the composition of Al/Ni. The probing of voltage‐current waveforms reveals that Al/Ni multilayer foils exhibit high voltage, short burst time and high absorbing energy in electrically heated in comparison with copper or nickel alone. We also measured the energy output of foils through velocity measurements of encapsulation layers ejected from bridge region by Photonic Doppler velocimetry. We observed flyer velocities from Al/Ni multilayer foil in the 1.6–2.9 km/s range, which is much higher than copper foil. Combined with the 1‐D non‐stationary acceleration model calculation, it is found that the chemical energy and increased electrical absorbing energy contributed to additional kinetic energy in the 40–80 mJ range.Keywords
This publication has 39 references indexed in Scilit:
- Equation of state of Al for compressed and expanded states from first-principles calculationsPhysica B: Condensed Matter, 2012
- Critical size, recovery, and mechanical property of nanoimprinted Ni–Al alloys investigation using molecular dynamics simulationComputational Materials Science, 2012
- Template-based synthesis of Ni nanorods on silicon substrateApplied Surface Science, 2012
- Publisher's Note: “A simple approach to neutral atom microscopy” [Rev. Sci. Instrum. 82, 103705 (2011)]Review of Scientific Instruments, 2011
- Influence of Al/CuO reactive multilayer films additives on exploding foil initiatorJournal of Applied Physics, 2011
- Formation of CuO nanowires by thermal annealing copper film deposited on Ti/Si substrateApplied Surface Science, 2011
- Pressure generated by the electric explosion of metal foilsTechnical Physics Letters, 2009
- Metal-based reactive nanomaterialsProgress in Energy and Combustion Science, 2009
- An algorithm for time evolving volume fractions in mixed zones in Lagrangian hydrodynamics calculationsRussian Journal of Physical Chemistry B, 2009
- Operating characteristics and modeling of the LLNL 100-kV electric gunIEEE Transactions on Plasma Science, 1989