Wireless and batteryless surface acoustic wave sensors for high temperature environments
- 1 August 2009
- conference paper
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 2-890
Abstract
Surface acoustic wave (SAW) devices are widely used as filter, resonator or delay line in electronic systems in a wide range of applications: mobile communication, TVs, radar, stable resonator for clock generation, etc. The resonance frequency and the delay line of SAW devices are depending on the properties of materials forming the device and could be very sensitive to the physical parameters of the environment. Since SAW devices are more and more used as sensor for a large variety of area: gas, pressure, force, temperature, strain, radiation, etc. The sensors based SAW present the advantage to be passive (batteryless) and/or wireless. These interesting properties combined with a small size, a low cost radio request system and a small antennas when operating at high frequency, offer new and exiting perspectives for wireless measurement processes and IDTAG applications. When the materials constituting the devices are properly selected, it becomes possible to use those sensors without embedded electronic in hostile environments (as high temperature, nuclear site, ...) where no solutions are currently used. General principle of the SAW sensor in wired and wireless configurations will be developed and a review of recent works concerning the field of high temperature applications will be presented with specific attention given to the choice of materials constituting the SAW device.Keywords
This publication has 8 references indexed in Scilit:
- Theoretical and experimental investigation of gigahertz-band, temperature-compensated electromechanical coupling configurations based on AlN filmsApplied Physics Letters, 2008
- Oxidation behavior of AlN films at high temperature under controlled atmosphereJournal of the European Ceramic Society, 2008
- Fabrication of high temperature surface acoustic wave devices for sensor applicationsSensors and Actuators A: Physical, 2005
- Platinum and palladium high-temperature transducers on langasiteIEEE Transactions on Ultrasonics, Ferroelectrics, and Frequency Control, 2005
- Performance of Zr and Ti adhesion layers for bonding of platinum metallization to sapphire substratesSensors and Actuators B: Chemical, 2001
- Electronic nose simulation of olfactory response containing 500 orthogonal sensors in 10 seconds1999
- Surface acoustic wave probe for chemical analysis. I. Introduction and instrument descriptionAnalytical Chemistry, 1979
- Measurement of SAW Velocity Versus Strain for YX and ST Quartz1975