Wettability of Y2O3: A Relative Analysis of Thermally Oxidized, Reactively Sputtered and Template Assisted Nanostructured Coatings
Open Access
- 29 February 2012
- journal article
- research article
- Published by MDPI AG in Nanomaterials
- Vol. 2 (1) , 65-78
Abstract
The wettability of reactively sputtered Y2O3, thermally oxidized Y-Y2O3 and Cd-CdO template assisted Y2O3 coatings has been studied. The wettability of as-deposited Y2O3 coatings was determined by contact angle measurements. The water contact angles for reactively sputtered, thermally oxidized and template assisted Y2O3 nanostructured coatings were 99°, 117° and 155°, respectively. The average surface roughness values of reactively sputtered, thermally oxidized and template assisted Y2O3 coatings were determined by using atomic force microscopy and the corresponding values were 3, 11 and 180 nm, respectively. The low contact angle of the sputter deposited Y2O3 and thermally oxidized Y-Y2O3 coatings is attributed to a densely packed nano-grain like microstructure without any void space, leading to low surface roughness. A water droplet on such surfaces is mostly in contact with a solid surface relative to a void space, leading to a hydrophobic surface (low contact angle). Surface roughness is a crucial factor for the fabrication of a superhydrophobic surface. For Y2O3 coatings, the surface roughness was improved by depositing a thin film of Y2O3 on the Cd-CdO template (average roughness = 178 nm), which resulted in a contact angle greater than 150°. The work of adhesion of water was very high for the reactively sputtered Y2O3 (54 mJ/m2) and thermally oxidized Y-Y2O3 coatings (43 mJ/m2) compared to the Cd-CdO template assisted Y2O3 coating (7 mJ/m2).Keywords
This publication has 45 references indexed in Scilit:
- A facile route for preparation of conjugated polymer functionalized inorganic semiconductors and direct application in hybrid photovoltaic devicesSolar Energy Materials and Solar Cells, 2010
- Monitoring of cell growth in vitro using biochips packaged with indium tin oxide sensorsSensors and Actuators B: Chemical, 2008
- Dye-doped inorganic/organic composite films as fluorescence sensors for methanol vaporSensors and Actuators B: Chemical, 2007
- Tin oxide and zinc oxide based doped humidity sensorsSensors and Actuators A: Physical, 2007
- Improvement of yeast biochip sensitivity using multilayer inorganic sol–gel substratesBiosensors and Bioelectronics, 2007
- Thin-film particles of graphite oxide. 2: Preliminary studies for internal micro fabrication of single particle and carbonaceous electronic circuitsCarbon, 2005
- Electrical and gas-sensing properties of mesostructured tin oxide-based H2 sensorSensors and Actuators B: Chemical, 2002
- Comparison of single and binary oxide MoO3, TiO2 and WO3 sol–gel gas sensorsSensors and Actuators B: Chemical, 2002
- Wettability of porous surfacesTransactions of the Faraday Society, 1944
- RESISTANCE OF SOLID SURFACES TO WETTING BY WATERIndustrial & Engineering Chemistry, 1936