Calculation of Planar Transformer Capacitance Based on the Applied Terminal Voltages
Authors:
- 9 November 2020
- conference paper
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 1-7
Abstract
In order to calculate the parasitic capacitors of a transformer, it is important to apply the correct transformer terminal voltages such that only the desired lumped capacitors are charged. This paper shows the correct transformer terminal voltages that match measurement scenarios that are widely used to extract lumped capacitor values. The parasitic capacitors are calculated based on the stored energy in the transformer windings for different measurement scenarios. A 5kW heavily interleaved high turns-ratio planar transformer is constructed, and its parasitic capacitance is measured. Lumped capacitor simulations are performed using Ansys Maxwell 3D. The simulations are verified through comparison with the measurements and the difference from the measurements is between 1.55-3.76%. The calculation method has a difference of 9.92-10.38% compared to the simulated model, which primarily is caused by an assumption of overlapping turns which is different from the simulated model.Keywords
This publication has 12 references indexed in Scilit:
- Planar Transformers With Near-Zero Common-Mode Noise for Flyback and Forward ConvertersIEEE Transactions on Power Electronics, 2017
- Analysis and design methodology for Planar Transformer with low self-capacitance used in high voltage flyback charging circuit2016
- Experimental Demonstration of a 98.8% Efficient Isolated DC–DC GaN ConverterIEEE Transactions on Industrial Electronics, 2016
- Investigation of Transformer Winding Architectures for High-Voltage (2.5 kV) Capacitor Charging and Discharging ApplicationsIEEE Transactions on Power Electronics, 2015
- Common-mode noise analysis, modeling and filter design for a phase-shifted full-bridge forward converter2015
- Common mode noise generation and filter design for a hard switched isolated full-bridge forward converter2014
- Design procedure for compact pulse transformers with rectangular pulse shape and fast rise timesIEEE Transactions on Dielectrics and Electrical Insulation, 2011
- Optimal Design and Tradeoff Analysis of Planar Transformer in High-Power DC–DC ConvertersIEEE Transactions on Industrial Electronics, 2010
- Impact of Power Density Maximization on Efficiency of DC–DC Converter SystemsIEEE Transactions on Power Electronics, 2009
- Self-Capacitance of High-Voltage TransformersIEEE Transactions on Power Electronics, 2007