Polyester Polyols from Microcellular Elastomer Scrap for Rigid Polyurethane and Polyisocyanurate Foam Production
Authors:
- 1 September 1989
- journal article
- Published by SAGE Publications in Cellular Polymers
- Vol. 8 (5) , 387-400
Abstract
Glycolysis products from microcellular elastomer polyurethane were used in the preparation of PUR-PIR rigid foams. Foams were generally good but, with a low NCO index, showed insufficient dimensional stability. The foam stability can be improved by an increase in the crosslinking density of the polymer, by using polyol components with an increased functionality or by increasing the isocyanurate content. The improved crosslinking induced by trimerisation is more efficient for stability than that derived by higher polyol functionality. The use of MDI with a high average functionality and glycolysis products with a relatively high equivalent weight, permit a more favourable MDI/polyol ratio and are therefore economical.Keywords
This publication has 8 references indexed in Scilit:
- Polyol Recovery from Elastomer Polyurethane WasteCellular Polymers, 1987
- Low Cost Compatibilizers for Waste Stream Polyester PolyolsJournal of Cellular Plastics, 1986
- A Comparison of Aromatic Polyester Polyols for Rigid Urethane and Isocyanurate FoamJournal of Cellular Plastics, 1985
- A Comparison of Propylene Oxide vs. Ethylene Oxide-Based Aromatic Polyester Polyols; Performance Evaluation in Rigid FoamJournal of Cellular Plastics, 1985
- New Polyester Polyols for Urethane Modified Isocyanurate FoamsJournal of Cellular Plastics, 1985
- New Polyols for Urethane Modified Isocyanurate FoamsJournal of Cellular Plastics, 1984
- Isocyanurate Rigid FoamJournal of Cellular Plastics, 1981
- Experimental confirmation of extent of reaction at the gel point in a polyisocyanurateJournal of Applied Polymer Science, 1979