Improving heat transfer in an air-cooled engine by redesigning the fins
Open Access
- 6 November 2024
- journal article
- Published by Polish Scientific Society of Combustion Engines in Combustion Engines
- Vol. 201 (2) , 14-21
Abstract
Heat transfer modelling and simulation were carried out in a single-cylinder, four-stroke, air-cooled engine to evaluate the heat transfer rate of the engine block. The modelling studies of cylinders with different numbers of fins and different geometry were performed using the SolidWorks computer platform. The tested components were made of 6063-T6 aluminium alloy castings. The simulation concerned different numbers of fins as well as changing the geometry of fins with circular and rectangular perforations. The results of the studies showed the possibility of improving the power to mass ratio for cylinder efficiency and heat transfer rate. It was shown that a large number of fins leads to an increased heat transfer rate, but it affects the overall engine efficiency due to the increase in the total engine mass. Circular perforation is a better design solution than rectangular perforated fins with the same cross-section. Circular perforation provides a lower engine cylinder mass and gives more than 4 % better heat transfer rate. The perforation size was tested using circular perforations with a diameter of 7.14 mm, 8.5 mm and 10 mm. With a 7.14 mm diameter perforation the heat transfer rate increases slightly compared to the other tested ones, while a 10 mm diameter perforation provides the best mass reduction.Keywords
This publication has 26 references indexed in Scilit:
- Experimental and numerical investigation of flow and heat transfer in lancet-type-finned cross-flow heat exchangersInternational Communications in Heat and Mass Transfer, 2024
- Optimising extended fin design and heat transfer coefficient for improved heat transfer and PCM recover time in thermal management of batteriesApplied Thermal Engineering, 2024
- Enhancement of photovoltaic module performance using passive cooling (Fins): A comprehensive reviewCase Studies in Thermal Engineering, 2023
- Derivation and validation of heat transfer model for Spark-Ignition engine cylinder headApplied Thermal Engineering, 2023
- Numerical evaluation of heat transfer effects on the improvement of efficiency of a spark ignition engine characterized by cylinder variabilityCase Studies in Thermal Engineering, 2022
- Effect of helical fins on the combustion performance in a micro-step combustorFuel, 2022
- Numerical investigation of thermo-hydraulic performance of an opposed piston opposed cylinder engine water jacket with helical finsApplied Thermal Engineering, 2019
- Experimental study on the effect of perforations shapes on vertical heated fins performance under forced convection heat transferInternational Journal of Heat and Mass Transfer, 2018
- Thermal performance of circular convective–radiative porous fins with different section shapes and materialsEnergy Conversion and Management, 2013
- Thermal performance of elliptical pin fin heat sink under combined natural and forced convectionExperimental Thermal and Fluid Science, 2013