Long-term wear effects on nanosilver release from commercially available food contact materials
- 22 August 2019
- journal article
- research article
- Published by Taylor & Francis in Food Additives & Contaminants: Part A
- Vol. 36 (11) , 1757-1768
Abstract
Potential consumer exposure to nanoparticles (NPs) from nanoenabled food contact materials (FCMs) has been a driving force for migration studies of NPs from FCMs. Although NP migration from fresh, unused FCMs was not previously observed, conditions that result in significant changes to the surface of FCMs have not been investigated for NP migration into food. Therefore, a quantitative assessment of nanoparticle release from commercially available nanosilver-enabled FCMs was performed using an abrasion protocol to simulate cleaning, cutting, scraping and other stressful use conditions. Laser scanning confocal microscopy (LSCM) analysis showed a general increase in root mean square (RMS) roughness after FCM abrasion, and particle count (for particle sizes from 80 nm to 960 nm) at the surface was 4 orders of magnitude higher for the abraded FCMs. Migration was evaluated using both water and 3% (v/v, volume fraction) acetic acid as food simulants. Low concentrations of total Ag were detected in water simulants with a small portion (−2) in the form of silver nanoparticles (AgNPs). Median particle diameter ranged from 39 nm to 50 nm with particle number concentrations on the order of 106 particles dm− 2. Total Ag migration into 3% (v/v) acetic acid was significantly higher than in water; however, 3% (v/v) acetic acid was not suitable for evaluation of NP release due to dissolution of AgNPs to Ag+ under acidic solution chemistries.Keywords
This publication has 32 references indexed in Scilit:
- Characterisation of food contact non-stick coatings containing TiO2 nanoparticles and study of their possible release into foodFood Additives & Contaminants: Part A, 2017
- Influence of aqueous food simulants on potential nanoparticle detection in migration studies involving nanoenabled food-contact substancesFood Additives & Contaminants: Part A, 2016
- Migration and characterisation of nanosilver from food containers by AF4-ICP-MSFood Chemistry, 2015
- Size-Controlled Dissolution of Silver Nanoparticles at Neutral and Acidic pH Conditions: Kinetics and Size ChangesEnvironmental Science & Technology, 2014
- Evaluation and Simulation of Silver and Copper Nanoparticle Migration from Polyethylene Nanocomposites to Food and an Associated Exposure AssessmentJournal of Agricultural and Food Chemistry, 2014
- Migration of silver from commercial plastic food containers and implications for consumer exposure assessmentFood Additives & Contaminants: Part A, 2013
- Release of Carbon Nanotubes from an Epoxy-Based Nanocomposite during an Abrasion ProcessEnvironmental Science & Technology, 2012
- Determining Transport Efficiency for the Purpose of Counting and Sizing Nanoparticles via Single Particle Inductively Coupled Plasma Mass SpectrometryAnalytical Chemistry, 2011
- Applications of nanotechnology in food packaging and food safety: Barrier materials, antimicrobials and sensorsJournal of Colloid and Interface Science, 2011
- Migration of silver from nanosilver–polyethylene composite packaging into food simulantsFood Additives & Contaminants: Part A, 2011