Single crystal flake parameters of MoS2 and MoSe2 exfoliated using anodic bonding technique and its potential in rapid prototyping
Open Access
- 1 October 2020
- journal article
- research article
- Published by IOP Publishing in Journal of Physics Communications
- Vol. 4 (10) , 105015
Abstract
Rapid prototyping of devices using exfoliated Molybednum di-Sulphide (MoS2) and Molybdenum di-Selenide (MoSe2) requires an experimental protocol for maximizing the probability of realizing flakes with desired physical dimension and properties. In this work, we analyzed the size and thickness distribution of MoS2 and MoSe2 single crystalline flakes exfoliated using anodic bonding technique and established a correlation between physical dimension of the flakes and the bonding parameters. Anodic bonding was carried out by applying a fixed voltage of 200 V with a set temperature of 150 °C for four different bonding time intervals. On analyzing the flake parameters from the four anodic bonded substrates using the optical and atomic force microscopy, it is found that the probability of getting flakes with large lateral size (>200 μm) increases as the bonding time interval is increased. Most of these large sized flakes have thickness of more than one hundred mono-layers and a tiny fraction of them have thickness of the order of few monolayers. A similar trend was also observed for MoSe2 single crystals. To demonstrate the feasibility of this technique in rapid prototyping, ultra thin MoS2 flakes was directly bridged between two ITO electrodes and their transport properties was investigated. Micro-Raman and photoluminescence studies were taken on selected regions of the thicker and thinner exfoliated flakes and their physical properties are compared.Keywords
Funding Information
- Anusandhan National Research Foundation (EMR/2016/002628)
This publication has 23 references indexed in Scilit:
- Photoluminescence emission and Raman response of monolayer MoS_2, MoSe_2, and WSe_2Optics Express, 2013
- High quality 2D crystals made by anodic bonding: a general technique for layered materialsNanotechnology, 2012
- Long-distance spin transport in high-mobility graphene on hexagonal boron nitridePhysical Review B, 2012
- van der Waals Bonding in Layered Compounds from Advanced Density-Functional First-Principles CalculationsPhysical Review Letters, 2012
- From Bulk to Monolayer MoS2: Evolution of Raman ScatteringAdvanced Functional Materials, 2012
- Single-layer MoS2 transistorsNature Nanotechnology, 2011
- Atomically Thin: A New Direct-Gap SemiconductorPhysical Review Letters, 2010
- Anodic bonded grapheneJournal of Physics D: Applied Physics, 2010
- Emerging Photoluminescence in Monolayer MoS2Nano Letters, 2010
- Graphene made easy: High quality, large-area samplesSolid State Communications, 2009