Fabrication of stepped hole on zirconia bioceramics by ultrasonic machining
Authors:
- 21 October 2016
- journal article
- review article
- Published by Taylor & Francis in Machining Science and Technology
- Vol. 20 (4) , 681-700
Abstract
Zirconia (ZrO2) is a highly biocompatible ceramic material providing fracture strength properties that allow application as dental implants in biomedical engineering. In this present research, experimental analysis has been made for generating stepped hole on zirconia bioceramics with desired quality using ultrasonic machining (USM) process. Four independent controllable input process parameters are abrasive grain diameter, power rating, concentration of abrasive slurry, and tool feed rate. Material removal rate (MRR), overcut of larger diameter (OLD) hole, and overcut of smaller diameter (OSD) hole of stepped hole are considered as the responses. Response surface methodology (RSM) is used for modeling the performance of USM process. Multiobjective optimization has been performed to maximize the MRR and minimize the OLD hole and OSD hole of stepped holes. All the responses are improved at the optimal parametric condition and verified by confirmation test. The present research opens up the application feasibility of USM process for stepped hole generation on bioceramics and its utilization in biomedical field.Keywords
This publication has 10 references indexed in Scilit:
- ULTRASONIC MACHINING—A COMPREHENSIVE REVIEWMachining Science and Technology, 2013
- Optimisation of ultrasonic machining of zirconia bio-ceramics using genetic algorithmInternational Journal of Manufacturing Technology and Management, 2013
- Analysis on profile accuracy for ultrasonic machining of alumina ceramicsThe International Journal of Advanced Manufacturing Technology, 2012
- Influence of the material removal mechanisms on hole integrity in ultrasonic machining of structural ceramicsUltrasonics, 2012
- Enabling and Understanding Ultrasonic Machining of Engineering Ceramics Using Parametric AnalysisMaterials and Manufacturing Processes, 2012
- Parameter Optimization of Ultrasonic Machining Process Using Nontraditional Optimization AlgorithmsMaterials and Manufacturing Processes, 2010
- Taguchi’s optimization of process parameters for production accuracy in ultrasonic drilling of engineering ceramicsProduction Engineering, 2009
- Material removal rate prediction for ultrasonic drilling of hard materials using an impact oscillator approachPhysics Letters A, 1999
- Machining of Engineering Ceramics by Ultrasonic Vibration Assisted EDM MethodMaterials and Manufacturing Processes, 1998
- Investigation of surface roughness and accuracy in ultrasonic machiningPrecision Engineering, 1988