New approach for the measurement of damping properties of materials using the Oberst beam
Authors:
- 1 August 2004
- journal article
- conference paper
- Published by AIP Publishing in Review of Scientific Instruments
- Vol. 75 (8) , 2569-2574
Abstract
The Oberst method is widely used for the measurement of the mechanical properties of viscoelastic or damping materials. The application of this method, as described in the ASTM E756 standard, gives good results as long as the experimental set-up does not interfere with the system under test. The main difficulty is to avoid adding damping and mass to the beam owing to the excitation and response measurement. In this paper, a method is proposed to skirt those problems. The classical cantilever Oberst beam is replaced by a double sized free-free beam excited in its center. The analysis is based on a frequency response function measured between the imposed velocity at the center (measured with an accelerometer) and an arbitrary point on the beam (measured with a laser vibrometer). The composite beam (base beam material) properties are first extracted from the measurement by an optimization algorithm. Young’s modulus and structural damping coefficient of the material under test can be deduced using classical formulations of the ASTM E756 standard for typical materials or using a finite element model for more complex cases. An application to a thick and soft viscoelastic material is presented, the results are shown to be consistent with Kramers–Kronig relations.
Keywords
This publication has 7 references indexed in Scilit:
- Polynomial relations for quasi-static mechanical characterization of isotropic poroelastic materialsThe Journal of the Acoustical Society of America, 2001
- LOSS FACTOR PEAK OF VISCOELASTIC MATERIALS: MAGNITUDE TO WIDTH RELATIONSJournal of Sound and Vibration, 2001
- Measurement methods of complex Poisson's ratio of viscoelastic materialsApplied Acoustics, 2000
- VERIFICATION OF LOCAL KRAMERS–KRONIG RELATIONS FOR COMPLEX MODULUS BY MEANS OF FRACTIONAL DERIVATIVE MODELJournal of Sound and Vibration, 1999
- On temperature-frequency analysis of polymer dynamic mechanical behaviourJournal of Sound and Vibration, 1990
- An Algorithm for Least-Squares Estimation of Nonlinear ParametersJournal of the Society for Industrial and Applied Mathematics, 1963
- A method for the solution of certain non-linear problems in least squaresQuarterly of Applied Mathematics, 1944