Heat source distribution, vertical structure, and coating influences on the temperature of operating 0.98 μm laser diodes: Photothermal reflectance measurements
- 1 October 1998
- journal article
- research article
- Published by AIP Publishing in Journal of Applied Physics
- Vol. 84 (7) , 3491-3499
Abstract
In the present work single-quantum-well laser diodes operating at 0.98 μm are investigated by photothermal reflectance microscopy. Temperature maps were obtained for the output facet of all devices studied. Furthermore, the temperature distribution was determined along the cavity (on the ridge) of lasers soldered with the junction side up. Near the facets, the measuredtemperature was found to be about seven times the bulk’s temperature, indicating the presence of an important surface heat source. The signal phase distribution of the laser facet shows the important role of the vertical structure on the heat confinement. Comparison between experiments and calculations shows that the confinement layers (GaAlAs and GaInP) thermal parameters are the principal responsible for the heat propagation in these structures near the active region. The same calculations show the role of the coating ( Al 2 O 3 ) in the heat propagation, and give a quantitative ratio between surface and bulk heat sources. Measurements made on the facet and on the ridge as a function of injection current were found to present a quite similar behavior, leading to the conclusion that thermal effects are strongly dominant in these measurements, masking any carrier or electroreflectance effects. Finally, measurements made under different light output power conditions and under the same injection current conditions showed that the surface heat source is caused by laser light absorption at the facets.Keywords
This publication has 10 references indexed in Scilit:
- Photothermal and electroreflectance images of biased metal-oxide-semiconductor field-effect transistors: Six different kinds of subsurface microscopyJournal of Applied Physics, 1997
- Thermal wave imaging of electrically heated microstructuresJournal of Applied Physics, 1996
- Optical strength of semiconductor laser materialsProgress in Quantum Electronics, 1996
- Temperature field determination of InGaAsP/InP lasers by photothermal microscopy: Evidence for weak nonradiative processes at the facetsApplied Physics Letters, 1994
- Micro-Temperature Measurements on Semiconductor Laser Mirrors by Reflectance Modulation: A Newly Developed Technique for Laser CharacterizationJapanese Journal of Applied Physics, 1993
- Temperature measurements of telecommunication lasers on a micrometre scaleElectronics Letters, 1993
- Influence of the vertical structure on the mirror facet temperatures of visible GaInP quantum well lasersApplied Physics Letters, 1993
- Auger recombination in modulated photoreflectance characterization of silicon wafersApplied Physics Letters, 1992
- Evidence for current-density-induced heating of AlGaAs single-quantum-well laser facetsApplied Physics Letters, 1991
- Thermal conductivity of binary, ternary, and quaternary III-V compoundsJournal of Applied Physics, 1988