Influence of the texturing quality consecutive to Abrasive Water Jet machining on the adhesive properties in mode I of 3D woven composite assemblies
Authors:
- X. SourdXSX. Sourd
- R. ZitouneRZR. Zitoune
- L. CrouzeixLCL. Crouzeix
- M. CoulaudMCM. Coulaud
- 25 June 2022
- journal article
- research article
- Published by Elsevier in Composites Part B: Engineering
- Vol. 242
Abstract
No abstract availableKeywords
Funding Information
- Safran Aircraft Engines
This publication has 16 references indexed in Scilit:
- Prediction of surface roughness in abrasive water jet machining of CFRP composites using regression analysisJournal of Alloys and Compounds, 2017
- Surface and machining induced damage characterization of abrasive water jet milled carbon/epoxy composite specimens and their impact on tensile behaviorWear, 2017
- Influence of Machining Process and Machining Induced Surface Roughness on Mechanical Properties of Continuous Fiber CompositesExperimental Mechanics, 2014
- Study of the surface defects and dust generated during trimming of CFRP: Influence of tool geometry, machining parameters and cutting speed rangeComposites Part A: Applied Science and Manufacturing, 2014
- Interlaminar toughness characterisation of 3D woven carbon fibre compositesPlastics, Rubber and Composites: Macromolecular Engineering, 2013
- Adhesively-bonded joints and repairs in metallic alloys, polymers and composite materials: Adhesives, adhesion theories and surface pretreatmentJournal of Materials Science, 2004
- Influence of surface morphology on the adhesion strength of epoxy–aluminum interfacesJournal of Adhesion Science and Technology, 2003
- Treatment of composite surfaces for adhesive bondingInternational Journal of Adhesion and Adhesives, 1993
- Toughness properties of a three-dimensional carbon-epoxy compositeJournal of Materials Science, 1989
- An Investigation of Milling With Abrasive-WaterjetsJournal of Engineering for Industry, 1989