Implantable Interface for an Arm Neuroprosthesis
Authors:
- Kristin ImenesKIKristin Imenes
- Lars-Cyril BlystadLars-Cyril Blystad
- Luca MarchettiLMLuca Marchetti
- Birgitte Kasin HonsvallBHBirgitte Kasin Honsvall
- Per OhlckersPOPer Ohlckers
- Saad RabbaniSRSaad Rabbani
- Carmen MoldovanCMCarmen Moldovan
- Octavian IonescuOIOctavian Ionescu
- Eduard FrantiEFEduard Franti
- Monica DascaluMDMonica Dascalu
- Lidia DobrescuLDLidia Dobrescu
- Dragos DobrescuDDDragos Dobrescu
- 13 September 2021
- conference paper
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 1-8
Abstract
This paper presents an ongoing development of an arm neuroprosthesis implantable interface consisting of a quadrupole implantable cuff-electrode, a neural analog front-end, a low power Arduino microcontroller, an off the shelf 433MHz transmitter, and a 3.7V 430mAh Li-Po battery. Implantable cuff electrode made of PDMS and Au has been successfully fabricated and tested for biocompatibility. A low power and low noise analog front-end were designed to filter and amplify the electroneurogram signal sensed by the cuff-electrode. The system was tested in the laboratory with input signals similar to the actual biological signals, verifying the correct operation of the implantable device. Finally, the analog front-end module was encapsulated in PDMS and implanted in the hind limb of a swine giving valuable training and knowledge for further development of the neuroprosthesis implantable interface.Keywords
This publication has 20 references indexed in Scilit:
- Control of Prosthetic Hands via the Peripheral Nervous SystemFrontiers in Neuroscience, 2016
- Design and Safety Considerations of an Implantable Rectenna for Far-Field Wireless Power TransferIEEE Transactions on Antennas and Propagation, 2014
- Wireless power transfer to deep-tissue microimplantsProceedings of the National Academy of Sciences, 2014
- Cytotoxic Effects of Gold Nanoparticles: A Multiparametric StudyACS Nano, 2012
- Improvement of signal-to-interference ratio and signal-to-noise ratio in nerve cuff electrode systemsPhysiological Measurement, 2012
- An Ultrasonically Powered Implantable Micro-Oxygen Generator (IMOG)IEEE Transactions on Biomedical Engineering, 2011
- Optimal Frequency for Wireless Power Transmission Into Dispersive TissueIEEE Transactions on Antennas and Propagation, 2010
- Modeling and Optimization of Printed Spiral Coils in Air, Saline, and Muscle Tissue EnvironmentsIEEE Transactions on Biomedical Circuits and Systems, 2009
- Direct neural sensory feedback and control of a prosthetic armIEEE Transactions on Neural Systems and Rehabilitation Engineering, 2005
- Power and Interactive Information Transmission to Implanted Medical Device Using UltrasonicJapanese Journal of Applied Physics, 2002