Analyzing the Effect of Machining Parameters Setting to the Surface Roughness during End Milling of CFRP-Aluminium Composite Laminates
Open Access
- 7 March 2016
- journal article
- research article
- Published by Wiley in International Journal of Manufacturing Engineering
- Vol. 2016, 1-9
Abstract
The quality of the machining is measured from surface finished and it is considered as the most important aspect in composite machining. An appropriate and optimum machining parameters setting is crucial during machining operation in order to enhance the surface quality. The objective of this research is to analyze the effect of machining parameters on the surface quality of CFRP-Aluminium in CNC end milling operation with PCD tool. The milling parameters evaluated are spindle speed, feed rate, and depth of cut. The Taguchi orthogonal arrays, signal-to-noise () ratio, and analysis of variance (ANOVA) are employed to analyze the effect of these cutting parameters. The analysis of the results indicates that the optimal cutting parameters combination for good surface finish is high cutting speed, low feed rate, and low depth of cut.
Keywords
Funding Information
- Ministry of Science Technology and Innovation Malaysia (06-01-04-SF1896)
- Ministry of Education Malaysia (06-01-04-SF1896)
This publication has 15 references indexed in Scilit:
- Machinability study of glass fibre-reinforced polymer composites during end millingThe International Journal of Advanced Manufacturing Technology, 2012
- Effect of Cutting Parameters on Cutting Force and Surface Roughness of Aluminium Components using Face Milling Process - a Taguchi ApproachIOSR Journal of Mechanical and Civil Engineering, 2012
- An optimization method of the machining parameters in high-speed machining of stainless steel using coated carbide tool for best surface finishThe International Journal of Advanced Manufacturing Technology, 2011
- Study of cutting speed on surface roughness and chip formation when machining nickel-based alloyJournal of Mechanical Science and Technology, 2010
- Surface roughness optimization in an end-milling operation using the Taguchi design methodJournal of Materials Processing Technology, 2007
- Selection of optimum tool geometry and cutting conditions using a surface roughness prediction model for end millingThe International Journal of Advanced Manufacturing Technology, 2005
- Effect of fibre direction on surface roughness measurements of machined graphite/epoxy compositeComposites Manufacturing, 1993
- Machinability characteristics of fibre reinforced plastics compositesJournal of Materials Processing Technology, 1988
- The cutting process, chips, and cutting forces in machining CFRPComposites, 1983
- A Theory of Machining of Fiber-Reinforced MaterialsJournal of Composite Materials, 1971