Ultra-Wideband Polarization Insensitive Thin Absorber Based on Resistive Concentric Circular Rings
- 5 March 2021
- journal article
- research article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Electromagnetic Compatibility
- Vol. 63 (5) , 1333-1340
Abstract
Eliminating stray and suppressing unwanted radiation in a high frequency circuit is difficult. It becomes a challenge to achieve an ultra-wide absorption band in a thin-single-layer microwave absorber. In this article, a novel polarization-independent, ultra-wideband, light-weight, thin microwave absorber has been investigated numerically and experimentally. The proposed absorber unit cell consists of two concentric circular rings loaded with lumped resistances placed on top surface of a dielectric substrate. Unit cell size is 0.28 λ $_{L}$ * 0.28 λ $_{L}$ * 0.067 λ $_{L}$ , which is compact in configuration (where λ $_{L}$ is the wavelength corresponding to lowest frequency of operation). The proposed design provides more than 90% absorption in the frequency range of 6.7 GHz to 20.58 GHz (fractional bandwidth of 101.7%). The novelty of the proposed work lies in designing a wideband and ultra-thin absorber by using optimum unit cell geometry, resistance loading, and air column loading. Combination of these techniques results in a very wide band absorber design. Four fold structural symmetricity makes the absorber polarization insensitive. The absorber is compact, light-weight (used air as spacer), and thin (only 0.067 λ $_{L}$ thick) and provides an alternative to construct wideband absorber for electromagnetic interference reduction.
Keywords
This publication has 29 references indexed in Scilit:
- Special Section on Wireless EMC and Wireless OTA MeasurementsIEEE Transactions on Electromagnetic Compatibility, 2017
- Broadband Polarization-Insensitive Tunable Frequency Selective Surface for Wideband ShieldingIEEE Transactions on Electromagnetic Compatibility, 2017
- Analysis and Design of Multilayered Broadband Radar Absorbing Metamaterial Using the 3-D Printing Technology-Based MethodIEEE Antennas and Wireless Propagation Letters, 2016
- Single-Layer Wideband Microwave Absorber Using Array of Crossed DipolesIEEE Antennas and Wireless Propagation Letters, 2016
- Analysis and Design of Three-Layer Perfect Metamaterial-Inspired Absorber Based on Double Split-Serration-Rings StructureIEEE Transactions on Antennas and Propagation, 2015
- A Circular-Ring Miniaturized-Element Metasurface With Many Good Features for Frequency Selective Shielding ApplicationsIEEE Transactions on Electromagnetic Compatibility, 2015
- Investigation of Thin and Broadband Capacitive Surface-Based Absorber by the Impedance Analysis MethodIEEE Transactions on Electromagnetic Compatibility, 2015
- Ultra-Thin Absorbers Comprised by Cascaded High-Impedance and Frequency Selective SurfacesIEEE Antennas and Wireless Propagation Letters, 2015
- The Two-Sheet Capacitive Jaumann AbsorberIEEE Transactions on Antennas and Propagation, 1995
- Reflection properties of the Salisbury screenIEEE Transactions on Antennas and Propagation, 1988