RETRACTED: Providing a model for Csf according to pool boiling convection heat transfer of water/ferrous oxide nanofluid using sensitivity analysis
- 13 June 2019
- journal article
- retracted article
- Published by Emerald Publishing in International Journal of Numerical Methods for Heat & Fluid Flow
- Vol. 30 (6) , 2867-2881
Abstract
A boiling surface with different initial roughness and under various nanoparticles volume fractions was studied in present work. Develop a correlation and sensitivity analysis. The results showed that for small (7.3 nm) and much larger (about 2,000 nm) surface roughness, compared to nanoparticle size of around 25 nm, the heat transfer rate of nanofluid diminishes relative to that of base fluid. The results also demonstrated that the boiling heat transfer rate is reduced by increasing the concentration of nanoparticles. For larger boiling surface roughness (480 nm) and nanoparticles volume fractions of less than 0.1 Vol.%, the value of heat transfer increases with the increase of nanoparticles concentration; and for those of more than 0.1 Vol.%, heat transfer rate decreases by adding more nanoparticles, significantly. Finally, an equation was presented for estimating the wall superheat and the Csf coefficient in terms of mentioned parameters.Keywords
This publication has 45 references indexed in Scilit:
- Simulation of copper–water nanofluid in a microchannel in slip flow regime using the lattice Boltzmann methodEuropean Journal of Mechanics - B/Fluids, 2015
- Mixed convection of copper–water nanofluid in a shallow inclined lid driven cavity using the lattice Boltzmann methodPhysica A: Statistical Mechanics and its Applications, 2014
- Pool boiling characteristics of nanofluid on flat plate based on heater surface analysisInternational Communications in Heat and Mass Transfer, 2013
- Experimental investigation of pool boiling heat transfer enhancement of alumina–water–ethylene glycol nanofluidsExperimental Thermal and Fluid Science, 2013
- Nucleate pool boiling heat transfer characteristics of TiO2–water nanofluids at very low concentrationsExperimental Thermal and Fluid Science, 2010
- Mechanism of enhancement/deterioration of boiling heat transfer using stable nanoparticle suspensions over vertical tubesJournal of Applied Physics, 2007
- Pool boiling heat transfer characteristics of ZrO2–water nanofluids from a flat surface in a poolHeat and Mass Transfer, 2007
- Pool boiling of nano-fluids on horizontal narrow tubesInternational Journal of Multiphase Flow, 2003
- Pool boiling characteristics of nano-fluidsInternational Journal of Heat and Mass Transfer, 2003
- Enhancement of pool boilingInternational Journal of Refrigeration, 1997