An online wear debris monitor
Authors:
- 1 July 1992
- journal article
- Published by IOP Publishing in Measurement Science and Technology
- Vol. 3 (7) , 656-661
Abstract
The design, construction and operation of a monitor for detecting metallic particulate contamination in lubricating oils is described. The principle of operation is that lubricating oil flows through a transducer coil, causing small changes in the inductance of a coil as any metallic particles pass. The coil is used as the resonating inductance in an oscillator, whose frequency is compared to a fixed crystal controlled oscillator in a phase locked loop (PLL). The PLL is arranged so that it compensates automatically for any slow drift in the oscillator frequency, while transient disturbances produced by metal particles can be detected and amplified. The direction of the frequency shift allows discrimination between ferrous and non-ferrous particles and the signal amplitude gives a measure of debris size and concentration.Keywords
This publication has 7 references indexed in Scilit:
- Automated measurement of tumour extent in patients with colorectal liver metastases from X-ray computed tomographyBritish Journal of Radiology, 1991
- An inductive method for estimating the composition and size of metal particlesMeasurement Science and Technology, 1990
- Noise in oscillatorsInternational Journal of Electronics, 1984
- Use of a capacitively coupled marginal oscillator for contactless transient conductivity measurementsReview of Scientific Instruments, 1980
- Light Scattering Instrumentation For Particulate Measurements In Processes1978
- NMR Marginal Oscillator with MOS-FET Operating at Low TemperatureJapanese Journal of Applied Physics, 1973
- Investigation of iron content of lubricating oil using a Ferrograph and an emission spectrometerWear, 1973