Investigation on the mold‐less curing process of 3D printing continuous carbon fiber reinforced thermoset composites based on thermoplastic shells constraint

Authors:
Publisher website
Google Scholar
Abstract
To overcome the dependence of continuous carbon fiber reinforced thermoset composites (CCFRTCs) on molds during the curing, a thermoset continuous fiber prepreg filament and thermoplastic filament alternate printing method was proposed. CCFRTCs with thin thermoplastic shells were prepared based on the method, and the confinement of thermoplastic shells enabled the mold‐less curing of CCFRTCs. The influence of key curing process parameters on the flexural properties of the specimens was systematically investigated. The experimental results showed that the flexural properties of the prepared composites were correlated positively with the vacuum degree and showed a tendency of first increasing and then decreasing with the increasement of impregnation time and curing temperature. Through x‐ray computed tomography (CT) and scanning electron microscope (SEM) analysis, the effect of key curing process parameters on the flexural properties of the CCFRTCs was clarified. Under the guidance of suitable curing process parameters, the flexural strength and modulus of the composite reached 482.89 MPa and 35.11 GPa, which were significantly better than most existing 3D printed continuous carbon fiber reinforced polymer composites. Finally, complex components were prepared to verify the feasibility and versatility of the technique. Highlights: A CCFRTCs mold‐less curing method was proposed. The effect of key parameters on the properties of CCFRTCs was clarified. Both the advantages of thermoset and thermoplastic materials were obtained. Complex components with low porosity were prepared.
Funding Information
  • National Natural Science Foundation of China (52075424)

This publication has 39 references indexed in Scilit: