Recycling of Waste Epoxy-Polyester Powders for Foam Production
- 1 July 2011
- journal article
- research article
- Published by IGI Global Scientific Publishing in International Journal of Manufacturing, Materials, and Mechanical Engineering
- Vol. 1 (3) , 10-20
Abstract
This paper proposes a new foaming technology (solid-state foaming) to produce structural foams from waste thermosetting resins. The proposed technology is easy and does not require specific and expensive equipments. Solid tablets are produced by cold compaction of resin powder, and foam by heating in an oven. Composite foams can be produced by mixing fillers and resin powder before the cold compaction. In the experiment, an epoxy-polyester (EP-PE) resin powder, deriving from the waste of a manufacturer of domestic appliances, was used with montmorillonite (MMT) particles. Resulting foams with a filler content ranging from 0 to 10 wt% were characterized in terms of physical and mechanical properties (by compression tests). Although the effect of the MMT content seems to be negative for the adopted resin, the feasibility of producing composite foams by recycling waste industrial powders is shown. The properties of the unfilled foams are sufficient for many industrial applications.Keywords
This publication has 7 references indexed in Scilit:
- Improvement of the mechanical properties of glass fibre reinforced plastic waste powder filled concreteConstruction and Building Materials, 2010
- Assessing the recycling potential of glass fibre reinforced plastic waste in concrete and cement compositesJournal of Cleaner Production, 2009
- Solid-State Foaming of Epoxy ResinJournal of Cellular Plastics, 2008
- Influence of fillers and additives on the cure kinetics of an epoxy/anhydride resinEuropean Polymer Journal, 2007
- Powder characteristics and coating conditions of fresh and reused polyester resins for electrostatic powder coating: powder recycling and loss preventionAdvanced Powder Technology, 2007
- Recycling technologies for thermoset composite materials—current statusComposites Part A: Applied Science and Manufacturing, 2006
- Solid-state foaming of titanium by hydrogen-induced internal-stress superplasticityScripta Materialia, 2003