Evaluation of chloride and pesticide transport in a fractured clayey till using large undisturbed columns and numerical modeling
Authors:
- Peter R. JørgensenPJPeter R. Jørgensen
- Peter R.PRPeter R.
- Larry D. McKayLMLarry D. McKay
- Niels H. SpliidNSNiels H. Spliid
- 1 April 1998
- journal article
- Published by American Geophysical Union (AGU) in Water Resources Research
- Vol. 34 (4) , 539-553
Abstract
Saturated groundwater flow and tracer experiments using fluorescent dye, chloride, and the herbicides mecoprop and simazine were carried out in the laboratory using three large‐diameter (0.5 m) undisturbed columns of fractured clayey till. Hydraulic conductivity of the columns ranged from 10−5 m/s in the shallowest column (1 m dept)) to 10−7 m/s in the deepest column (4 m depth) and were similar to field‐measured values for these deposits. Results of the tracer experiments are consistent with a conceptual model of advective transport along the fractures combined with diffusion into the fine‐grained matrix between the fractures. Arrival of the chloride tracer in the effluent was highly retarded relative to fracture flow velocities calculated on the basis of the cubic law and measured values of fracture spacing and hydraulic conductivity. The herbicides were more strongly retarded than the chloride at low flow rates, but at higher flow rates the herbicides arrived with the chloride, indicating the influence of nonequilibrium sorption of the herbicides to fracture walls and the matrix solids. The columns were dismantled following the tracer experiments and mapping under UV light showed that nearly all of the visible, weathered fractures (and the few root holes in the case of the shallowest sample) were active transport pathways, with the dye appearing mainly on the fracture surfaces and as a “rim” in the adjacent matrix. Concentration profiles measured perpendicular to the fracture surfaces showed that the herbicides had also moved into the matrix, apparently by diffusion. Simulations of solute transport with a discrete fracture flow/matrix diffusion model showed that the simulations could be “fit” to the data if all of the visible fractures were hydraulically active, but could not be fit if all or most of the flow was channelled through just the primary fractures (defined by prominent oxidation stains). Simulations with an equivalent porous media (EPM) model could not fit the data using the measured total porosity as the effective porosity. The simulations could likely be fit with a smaller value of effective porosity, but this would limit applicability to field situations because fitted effective porosity is expected to change with physical scale and residence time of the solute in the soil.Keywords
This publication has 31 references indexed in Scilit:
- Floods, channel change, and the hyporheic zoneWater Resources Research, 1999
- Movement of pesticides to surface waters from a heavy clay soilPesticide Science, 1995
- Influence of different field sites on pesticide movement into subsurface drainsPesticide Science, 1995
- Field experiments in a fractured clay till: 1. Hydraulic conductivity and fracture apertureWater Resources Research, 1993
- Modeling solute transport in structured soils: a reviewGeoderma, 1990
- Fracture effects in the shallow groundwater zone in weathered Sarnia-area clayCanadian Geotechnical Journal, 1989
- Continuum models for contaminant transport in fractured porous formationsWater Resources Research, 1988
- Fracture permeability and groundwater flow in clayey till near Saskatoon, SaskatchewanCanadian Geotechnical Journal, 1986
- An efficient finite element technique for modeling transport in fractured porous media: 1. Single species transportWater Resources Research, 1983
- Origin, age and movement of pore water in argillaceous Quaternary deposits at four sites in southwestern OntarioJournal of Hydrology, 1981