Hardening mechanism of high manganese steel during impact abrasive wear
Authors:
- Jie LiJLJie Li
- Liujie XuLXLiujie Xu
- Yu FengYFYu Feng
- Shubo WuSWShubo Wu
- Wei LiWLWei Li
- Qiwei WangQWQiwei Wang
- Peng ZhangPZPeng Zhang
- Xiaohui TuXTXiaohui Tu
- 15 October 2023
- journal article
- research article
- Published by Elsevier in Engineering Failure Analysis
- Vol. 154
Abstract
No abstract availableKeywords
This publication has 26 references indexed in Scilit:
- Thermal and mechanical stability of retained austenite surrounded by martensite with different degrees of temperingMaterials Science and Engineering: A, 2017
- Understanding martensite and twin formation in austenitic steels: A model describing TRIP and TWIP effectsActa Materialia, 2017
- The effects of prior austenite grain boundaries and microstructural morphology on the impact toughness of intercritically annealed medium Mn steelActa Materialia, 2017
- Comparison of three-body impact abrasive wear behaviors for quenching–partitioning–tempering and quenching–tempering 20Si2Ni3 steelsWear, 2016
- Wear behavior and work hardening of high strength steels in high stress abrasionWear, 2015
- A novel high manganese austenitic steel with higher work hardening capacity and much lower impact deformation than Hadfield manganese steelMaterials & Design (1980-2015), 2014
- Consumption of steel grinding media in mills – A reviewMinerals Engineering, 2013
- Materials challenges in nuclear energyActa Materialia, 2013
- Derivation and Variation in Composition-Dependent Stacking Fault Energy Maps Based on Subregular Solution Model in High-Manganese SteelsMetallurgical and Materials Transactions A, 2009
- Correlations between the calculated stacking fault energy and the plasticity mechanisms in Fe–Mn–C alloysMaterials Science and Engineering: A, 2004