Fabrication, Performance, Characterization and Experimental Calibration of Embedded Thin-Film Sensor for Tool Cutting Force Measurement
Open Access
- 17 February 2022
- journal article
- research article
- Published by MDPI AG in Micromachines
- Vol. 13 (2) , 310
Abstract
Thin-film strain sensors are widely used because of their small volume, fast strain response and high measurement accuracy. Among them, the thin-film material and preparation process of thin-film strain sensors for force measurement are important aspects. In this paper, the preparation process parameters of the transition layer, insulating layer and Ni-Cr alloy layer in a thin-film strain sensor are analyzed and optimized, and the influence of each process parameter on the properties of the thin film are discussed. The surface microstructure of the insulating layer with Al2O3 or Si3N4 transition layers and the film without transition layer were observed by atomic force microscopy. It is analyzed that adding a transition layer between the stainless steel substrate and insulation layer can improve the adhesion and flatness of the insulation layer. The effects of process parameters on elastic modulus, nanohardness and strain sensitivity coefficient of the Ni-Cr resistance layer are discussed, and electrical parameters such as the resistance strain coefficient are analyzed and characterized. The static calibration of the thin-film strain sensor is carried out, and the relationship between the strain value and the output voltage is obtained. The results show that the thin-film strain sensor can obtain the strain generated by the cutting tool and transform it into an electrical signal with good linearity through the bridge, accurately measuring the cutting force.Keywords
Funding Information
- National Natural Science Foundation of China (51875533)
- Shanxi Provincial Natural Science Foundation of China (201901D111130, 201901D111179)
This publication has 31 references indexed in Scilit:
- Design and Theoretical Analysis of an Embedded Thin Film SensorMaterials Science Forum, 2014
- Comparison of microstructure and electrical properties of NiCr alloy thin film deposited on different substratesSurface and Coatings Technology, 2013
- Optimization of sputtering parameters for Ni–Cr alloy deposition on copper foil as embedded thin film resistorSurface and Coatings Technology, 2013
- Hydrogen permeation through silicon nitride filmsJournal of Alloys and Compounds, 2012
- Characterisation of the silicon nitride thin films deposited by plasma magnetronSurface and Interface Analysis, 2008
- Design, development and testing of a four-component milling dynamometer for the measurement of cutting force and torqueMechanical Systems and Signal Processing, 2007
- Correction of dynamic effects on force measurements made with piezoelectric dynamometersInternational Journal of Machine Tools and Manufacture, 2006
- Design, development and testing of a turning dynamometer for cutting force measurementMaterials & Design (1980-2015), 2006
- Studies of the composition, tribology and wetting behavior of silicon nitride films formed by pulsed reactive closed-field unbalanced magnetron sputteringNuclear Instruments and Methods in Physics Research Section B: Beam Interactions with Materials and Atoms, 2005
- Mechanical properties of TiN thin film coatings on 304 stainless steel substratesSurface and Coatings Technology, 2002