Closing a Second Feedback Loop in a DC–DC Converter Based on a Piezoelectric Transformer
- 12 November 2007
- journal article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Power Electronics
- Vol. 22 (6) , 2195-2201
Abstract
Nowadays, piezoelectric transformers (PT) are a good alternative to substitute magnetic materials in AC/DC and DC-DC converters. They have high isolation voltage and operate at higher frequencies than magnetics, with lower losses. However, their optimum operating frequency exhibits a strong dependence on different parameters, such as temperature, load, or even voltage level applied. This is usually an inconvenience, because this drift affects PT gain and efficiency, which can vary enormously within a few hundred of hertz. On the other hand, not only is it necessary to ensure the PT is driven at the proper frequency - in terms of gain and efficiency, including zero voltage switching in the power stage - output voltage must also be regulated. In this paper, two simple feedback loops are implemented in a PT-based DC-DC converter. One of them adjusts the switching frequency to obtain the best gain and efficiency. The other one performs the output voltage regulation.Keywords
This publication has 15 references indexed in Scilit:
- Design of half-bridge piezo-transformer converters in the AC adapter applications2005
- Feedback isolation by piezoelectric transformers: comparison of amplitude to frequency modulation2004
- A New Control Strategy for an AC/DC Converter Based on a Piezoelectric TransformerIEEE Transactions on Industrial Electronics, 2004
- Consideration of a single-switch inverter for piezoelectric transformer with a new control method2004
- Transcutaneous battery charger using a half bridge SRC controlled by resonant current phase2003
- Design considerations for achieving ZVS in a half bridge inverter that drives a piezoelectric transformer with no series inductor2003
- Piezoelectric transformer converter with PWM control2002
- Electronic ballast using piezoelectric transformers for fluorescent lamps2002
- Generic operational characteristics of piezoelectric transformers2002
- A new full-protected control mode to drive piezoelectric transformers in DC-DC convertersIEEE Transactions on Power Electronics, 2002