Performance of Graphite Foam Evaporator for Use in Thermal Management
- 1 June 2004
- journal article
- Published by ASME International in Journal of Electronic Packaging
- Vol. 127 (2) , 127-134
Abstract
This paper presents the results of an investigation of the thermal performance of a graphite foam thermosyphon evaporator and discusses the foam’s potential for use in the thermal management of electronics. The graphitized carbon foam used in this study is an open-cell porous material that consists of a network of interconnected graphite ligaments whose thermal conductivities are up to five times higher than copper. While the bulk graphite foam has a thermal conductivity similar to aluminum, it has one-fifth the density, making it an excellent thermal management material. Furthermore, using the graphite foam as the evaporator in a thermosyphon enables the transfer of large amounts of energy with relatively low temperature difference and without the need for external pumping. Performance of the system with FC-72 and FC-87 was examined, and the effects of liquid fill level, condenser temperature, and foam height, width, and density were studied. Performance with FC-72 and FC-87 was found to be similar, while the liquid fill level, condenser temperature, geometry, and density of the graphite foam were found to significantly affect the thermal performance. The boiling was found to be surface tension dominated, and a simple model based on heat transfer from the outer surface is proposed. As much as were dissipated from a heated area.
Keywords
This publication has 7 references indexed in Scilit:
- Effects of Varying Geometrical Parameters on Boiling From Microfabricated Enhanced StructuresJournal of Heat Transfer, 2003
- Combined effects of sub-cooling and operating pressure on the performance of a two-chamber thermosyphonIEEE Transactions on Components and Packaging Technologies, 2000
- High-thermal-conductivity, mesophase-pitch-derived carbon foams: effect of precursor on structure and propertiesCarbon, 2000
- Thermal Performance of a Compact Two-phase Thermosyphon: Response to Evaporator Confinement and Transient LoadsJournal of Enhanced Heat Transfer, 1999
- Optimization of Enhanced Surfaces for High Flux Chip Cooling by Pool BoilingJournal of Electronic Packaging, 1993
- Microelectronic Cooling by Enhanced Pool Boiling of a Dielectric Fluorocarbon LiquidJournal of Heat Transfer, 1989
- Thermal conductivity of aluminum, copper, iron, and tungsten for temperatures from 1 K to the melting point1984