A Per-Unit Hardware-in-the-Loop Simulation of a Fuel Cell/Battery Hybrid Energy System
Authors:
- 24 November 2009
- journal article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Industrial Electronics
- Vol. 57 (4) , 1186-1194
Abstract
Nowadays, hybrid energy systems have a great applicability for both vehicle and stationary purposes. The design, development, and testing of these systems are not straightforward due to the high number of elements involved, the complexity, and cost. Hardware-in-the-loop (HIL) is an appropriate approach to simulate the hybrid system as it combines both physical and simulated elements. However, the HIL simulation sizing may vary from watts to megawatts, depending on the application. If, instead of carrying out the simulation in absolute values, it is carried out in per-unit (p.u.) values, the HIL test bench will be independent of the application power rating. Hence, a p.u. HIL test bench to simulate a hybrid energy system is proposed. To prove the usefulness and applicability of the HIL simulation presented, a particular fuel-cell hybrid electric vehicle is simulated in real time. Results show that the proposed p.u. HIL simulation is appropriate for the simulation of high-power systems.Keywords
This publication has 22 references indexed in Scilit:
- Per unit representation of electrical magnitudes in batteries: A tool for comparison and designEnergy Conversion and Management, 2009
- Evaluating dynamic performance of modern electric drives via power-hardware-in-the-loop simulation2008
- Energy Storage Systems for Automotive ApplicationsIEEE Transactions on Industrial Electronics, 2008
- Hybrid Electric Vehicles: Architecture and Motor DrivesProceedings of the IEEE, 2007
- A Low-Cost Real-Time Hardware-in-the-Loop Testing Approach of Power Electronics ControlsIEEE Transactions on Industrial Electronics, 2007
- Test platform for hybrid electric power systems: Development of a HIL test platform2007
- Fuel cell equivalent circuit models for passive mode testing and dynamic mode design2006
- The VRLA modular wound design for 42 V mild hybrid systemsJournal of Power Sources, 2003
- Electrochemical impedance spectroscopy of porous electrodes: the effect of pore size distributionElectrochimica Acta, 1999
- Fundamentals of Vehicle Dynamics1992