Impact of 3D-printed rods occupancy on photonic crystal transmission properties
- 2 April 2025
- journal article
- Published by IOP Publishing in Physica Scripta
- Vol. 100 (5) , 055507
Abstract
In this study, the effect of different filling ratios on the transmission properties of rods printed by a 3D printer when using them in a photonic crystal cavity structure was investigated. First, the dielectric constant was measured experimentally for two different PLA (Polylactic Acid) and ABS (Acrylonitrile Butadiene Styrene) materials commonly used in 3D printers. Then, dielectric rods were printed with different filling ratios. The printed rod was transferred to the Lumerical FDTD software program and the photonic crystal cavity structure containing this rod was analyzed. The dispersion diagrams of the structure and the transmission spectrum were obtained. Then, these rods printed in the experimental stage were placed in the photonic crystal cavity structure containing the Alumina rod, and measurements were taken in the microwave region. As a result, it was seen that the dispersion properties of the structure were affected by the filling ratio. It was observed that with the decrease in the effective index of the rod, the band gap shifted upwards, and the bandwidth decreased, and when the rod was used in the cavity, the resonant transmission frequency shifted. This study can be a guide in determining the deviation range that occurs in designs to be made using 3D prints in communication applications.Keywords
Funding Information
- Scientific and Technological Research Council of Turkey (118E954)
- Pamukkale University Scientific Research Project Unit (BAP- 2020FEBE001)
This publication has 26 references indexed in Scilit:
- The effect of symmetry breaking in coupled cavity photonic crystal waveguide on dispersion characteristicsOptical and Quantum Electronics, 2024
- 3D printed optics and photonics: Processes, materials and applicationsMaterials Today, 2023
- 3D printing technique and its application in the fabrication of THz fibers and waveguidesJournal of Applied Physics, 2023
- 3D Printed Fabry–Pérot Filters for Terahertz Spectral RangeJournal of Infrared, Millimeter, and Terahertz Waves, 2022
- A comprehensive review on effective medium theories to find effective dielectric constant of compositesJournal of Electromagnetic Waves and Applications, 2022
- Photonic crystal bandpass filter exploiting the degenerate modes tunable with MEMS actuator for terahertz applicationMicrowave and Optical Technology Letters, 2021
- An iterative approach to determine the refractive index of 3D printed 60GHz PLA lenses2018
- THz Optics 3D Printed with TOPASJournal of Infrared, Millimeter, and Terahertz Waves, 2015
- Optical Properties of 3D Printable Plastics in the THz Regime and their Application for 3D Printed THz OpticsJournal of Infrared, Millimeter, and Terahertz Waves, 2014
- Photonic bands: Convergence problems with the plane-wave methodPhysical Review B, 1992