Effects of Dwell Time on the Deformation and Fatigue Behaviour of A356-T7 Cast Aluminium Alloys Used in High Specific Power IC Engine Cylinder Heads
Open Access
Abstract
The electrification of automotive powertrains in recent years has been driving the development of internal combustion engines towards reduced volumes with higher power outputs. These changes place extreme demands on engine materials. Engineers employ the computer-aided engineering approach to design reliable and cost-effective engines. However, this approach relies on accurate knowledge of the material deformation and fatigue characteristics during service-like loading. The present study seeks to investigate the effect of dwell times on the deformation and fatigue behaviour of the A356-T7 + 0.5 wt.% Cu alloy used to cast cylinder heads. In particular, we study the effect of dwell time duration at various temperatures. A combined fatigue-dwell testing procedure, with the dwell at the maximum compressive strain, replicates the service conditions. It is found that the material exhibits a stress relaxation behaviour with a decreasing relaxation rate. At lower temperatures, the load level influences the relaxation more than at elevated temperatures. However, the dwell does not significantly affect the hardening behaviour or the life of the tested alloy. Finally, we model the time-dependent material behaviour numerically. The Chaboche model, combined with a Cowper–Symonds power-law, is found to capture the visco-plastic deformation behaviour accurately.Keywords
Funding Information
- Energimyndigheten (37807-1)
This publication has 36 references indexed in Scilit:
- Hold-time effect on the thermo-mechanical fatigue crack growth behaviour of Inconel 718Materials Science and Engineering: A, 2011
- Re-examination of creep behaviour of high purity aluminium at low temperatureJournal of Physics: Conference Series, 2010
- Behavior, damage and fatigue life assessment of lost foam casting aluminum alloys under thermo-mechanical fatigue conditionsProcedia Engineering, 2010
- Lifetime of cast AlSi6Cu4 under superimposed thermal–mechanical fatigue and high-cycle fatigue loadingMaterials Science and Engineering: A, 2008
- Thermomechanical design in the automotive industryFatigue & Fracture of Engineering Materials & Structures, 2004
- Fatigue design of structures under thermomechanical loadingsFatigue & Fracture of Engineering Materials & Structures, 2002
- Mechanical modeling and microstructural observation of pure aluminum crept under constant stressMaterials Science and Engineering: A, 2002
- Normalized life prediction in terms of stress relaxation behavior under creep–fatigue interactionMaterials Letters, 2001
- Stress relaxation and creep of some aluminium alloysMaterials Science and Engineering, 1985
- Paper 7: Cyclic Stress Induced Creep of Close-Packed MetalsProceedings of the Institution of Mechanical Engineers, Conference Proceedings, 1963