Wear and Tribological Performance of Different Ceramic Tools in Dry High Speed Machining of Ni-Co-Cr Precipitation Hardenable Aerospace Superalloy
- 25 October 2018
- journal article
- research article
- Published by Taylor & Francis in Tribology Transactions
- Vol. 62 (1) , 62-77
Abstract
Tool wear is an important machinability criterion. For the sake of reduction of the total machining cost; this study demonstrates the wear and tribological performance of four ceramic tools in dry high speed turning of Ni-Co-Cr precipitation hardenable superalloy (Inconel 100). Wear of the tool materials and the structural and phase transformations at the tool/chip interface were investigated. Results obtained reveal that SiAlON ceramic outperformed other ceramic tool materials at different cutting speeds due to the formation large amount of mullite tribo-films on the tool face, which serve as a thermal barrier layer. Alumina ceramic with addition of ZrO2 can be recommended for machining Inconel 100 at speeds above 150 m/min due its ability to form thermal barrier ZrO2tribo-films, which decrease of coefficient of friction at the tool chip/interface. Mixed alumina and alumina matrix reinforced with SiCw were found to be not suitable for machining age-hardened Inconel 100 superalloy.Keywords
Funding Information
- This research was supported by Natural Sciences and Engineering Research Council of Canada (NSERC) under the CANRIMT Strategic Research Network
This publication has 56 references indexed in Scilit:
- Laser Assisted Machining of Difficult to Cut Materials: Research Opportunities and Future Directions - A Comprehensive ReviewProcedia Engineering, 2014
- Effect Tool Wear During End Milling on the Surface Integrity and Fatigue Life of Inconel 718Procedia CIRP, 2014
- Increasing Cutting Tool Life when Machining Inconel 718Procedia Engineering, 2014
- Thermally enhanced machining of hard-to-machine materials—A reviewInternational Journal of Machine Tools and Manufacture, 2010
- A review of developments towards dry and high speed machining of Inconel 718 alloyInternational Journal of Machine Tools and Manufacture, 2004
- An overview of the machinability of aeroengine alloysJournal of Materials Processing Technology, 2003
- The machinability of nickel-based alloys: a reviewJournal of Materials Processing Technology, 1999
- Machinability of nickel-base super alloys: a general reviewJournal of Materials Processing Technology, 1998
- The machinability of inconel 718Journal of Materials Processing Technology, 1997
- Use of ceramic tools for machining nickel based alloysInternational Journal of Machine Tools and Manufacture, 1989