Piezoelectric Materials for Biomedical Applications
Authors:
- 15 March 2007
- journal article
- Published by Trans Tech Publications, Ltd. in Key Engineering Materials
- Vol. 334-335, 1117-1120
Abstract
A piezoelectric microactuator for minimally invasive surgery procedures was developed using the piezoelectric tube actuator. The tube was fabricated by electrophoretic deposition of a doped PZT powders on the graphite rod substrate and co-sintering. The obtained tube shows maximum strain 0.045% in 31 mode and coercive field 1.5 kV/mm under static condition. Under dynamic condition, bending and longitudinal vibration modes can be identified from impedance spectrum and simulation. Theoretical analysis indicates that the displacement of the two modes depends on the geometry, material property, driving condition and damping conditions. The developed device uses bending mode to create rotation mechanical motion, and longitudinal mode to produce ultrasonic energy to soften and break up the target into fragments.Keywords
This publication has 7 references indexed in Scilit:
- Investigation on the electrophoretic deposition of a FGM piezoelectric monomorph actuatorJournal of Materials Science, 2003
- Cylindrical Micro Ultrasonic Motor Utilizing Bulk Lead Zirconate Titanate (PZT)Japanese Journal of Applied Physics, 1999
- Novel piezoelectric ceramics and composites for sensor and actuator applicationsMaterials Research Innovations, 1999
- Piezoelectric Materials and their ApplicationsKey Engineering Materials, 1996
- Piezoelectric Actuators and Ultrasonic Motors1996
- Single-tube three-dimensional scanner for scanning tunneling microscopyReview of Scientific Instruments, 1986
- Large electrostrictive effects in relaxor ferroelectricsFerroelectrics, 1980