Kinetics of silica precipitation on quartz seeds at 200–300 °C

Authors:

Abstract
Ing; and (3) 0.1 N NaOH solution for the removal of F – . The quartz was washed with distilled water between the treatments of various solutions. After the treatment, quartz was again washed with distilled water up to the pH of the initial water. During the last washing procedure, sedimentation separation was repeatedly carried out in order to remove small particles that were formed during solution etching. The washed quartz powder was dried at 105°ë . The described procedure of starting material preparation for experiments is widely used for the investigation of the kinetics of both quartz dissolution and precipitation [4‐6]. The surface area of the purified quartz powder was determined by the BET nitrogen adsorption method in six points as 0.68 m 2 /g. According to the data of X-ray diffraction analysis, the quartz is represented by the low-temperature variety ( α -quartz) and is free of other minerals. According to X-ray fluorescence analysis, the quartz contained the following impurities (%): 0.007 Na 2 O, 0.013 K 2 O, 0.025 CaO, 0.004 MgO, 0.14 Fe 2 O 3 , 0.30 Al 2 O 3 , 0.013 SO 3 , and 0.007 P 2 O 5 . The quartz glass that was used to obtain silica-oversaturated solutions was prepared by crushing transparent twice-melted quartz tubes. The crushed glass was sieved through brass sieves and a fraction of 0.1‐0.2 mm was separated. This fraction was cleaned from dustlike particles by repeated ultrasonic washing in water. Distilled water saturated in atmospheric CO 2 (pH 5.6) was used as a liquid phase in the experiments.

This publication has 14 references indexed in Scilit: