Mixing Process in High Pressure Diesel Jets by Normalized Laser Induced Exciplex Fluorescence Part I: Free Jet
- 11 May 2005
- conference paper
- Published by SAE International in SAE International Journal of Advances and Current Practices in Mobility
- Vol. 1
Abstract
The mixing process of High Pressure Diesel jets is studied using normalized laser induced exciplex fluorescence (LIEF). A single hole common rail Diesel injector is used which allows high injection pressures up to 200MPa. The spray is observed in a high pressure, high temperature cell that reproduces the thermodynamic conditions which exist in the combustion chamber of a Diesel engine during injection. A LIEF technique is combined to a normalization method in order to obtain fuel vapor concentration fields. A detailed statistical analysis is then used to describe the jet mixing process. Mixing is strong in the stationary zone, located upstream, while it is much weaker at the tip of the jet. The effect of varying the injection parameters has also been investigated. In particular, it has been shown that the local mixing rate in the stationary zone remains constant despite an increase in the injection pressure. Also, it has been observed that the nozzle hole diameter has a significant effect on the global mixing rate. A reduction of nozzle hole diameter from 0.15 to 0.1mm improves the local mixing rate in the stationary zone. However, an increase in hole diameter from 0.15 to 0.2mm has similarly been shown to improve the global mixing, since the increase in mass momentum then compensates for the reduction in local mixing rate. Finally, a study of short injection timings shows that the mixing rate is conserved after the end of injection resulting in a rapid decrease of the maximum fuel jet concentration.Keywords
This publication has 16 references indexed in Scilit:
- Mixing Process in High Pressure Diesel Jets by Normalized Laser Induced Exciplex Fluorescence Part II: Wall Impinging Versus Free JetSAE International Journal of Advances and Current Practices in Mobility, 2005
- A Study of Mixture Formation in Direct Injection Diesel Like Conditions Using Quantitative Fuel Concentration Visualizations in a Gaseous Fuel JetSAE International Journal of Advances and Current Practices in Mobility, 2002
- LIQUID AND VAPOR SPRAY STRUCTURE IN HIGH-PRESSURE COMMON RAIL DIESEL INJECTIONAtomization and Sprays, 2001
- Macroscopic and Ignition Characteristics of High-Pressure Sprays of Single-Component FuelsSAE International Journal of Advances and Current Practices in Mobility, 1998
- Liquid-Phase Fuel Penetration in Diesel SpraysSAE International Journal of Advances and Current Practices in Mobility, 1998
- Quantitative Analysis of Fuel Vapor Concentration in Diesel Spray by Exciplex Fluorescence MethodSAE International Journal of Advances and Current Practices in Mobility, 1997
- Characteristics of Free and Impinging Gas Jets by Means of Image ProcessingSAE International Journal of Advances and Current Practices in Mobility, 1997
- Quantitative 2-D Fuel Vapor Concentration Imaging in a Firing D.I. Diesel Engine Using Planar Laser-Induced Rayleigh Scattering *SAE International Journal of Advances and Current Practices in Mobility, 1994
- A Comparison of the Bosch and Zuech Rate of Injection MetersSAE International Journal of Advances and Current Practices in Mobility, 1991
- Ignition Delay Characteristics of Alternative Diesel Fuels: Implications on Cetane NumberSAE International Journal of Advances and Current Practices in Mobility, 1985