Interfacial Properties of Lignin-Based Electrospun Nanofibers and Films Reinforced with Cellulose Nanocrystals
- 27 November 2012
- journal article
- research article
- Published by American Chemical Society (ACS) in ACS Applied Materials & Interfaces
- Vol. 4 (12) , 6849-6856
Abstract
Sub-100 nm resolution local thermal analysis, X-ray photoelectron spectroscopy (XPS), and water contact angle (WCA) measurements were used to relate surface polymer distribution with the composition of electrospun fiber mats and spin coated films obtained from aqueous dispersions of lignin, polyvinyl alcohol (PVA), and cellulose nanocrystal (CNC). Defect-free lignin/PVA fibers were produced with radii which were observed to increase with lignin concentration and with the addition of CNCs. XPS and WCA results indicate a nonlinear relationship between the surface and the bulk compositions. A threshold around 50 wt % bulk composition was identified in which extensive partitioning of PVA and lignin components occurred on the surface below and above this value. In 75:25 wt % lignin/PVA solvent cast films, phase separated domains were observed. Using nanoscale thermal analyses, the continuous phase was determined to be lignin-rich and the discontinuous phase had a lignin/PVA dispersion. Importantly, the size of the phase separated domains was reduced by the addition of CNCs. When electrospun fiber surfaces were lignin-rich, the addition of CNCs affected their surfaces. In contrast, no surface effects were observed with the addition of CNCs in PVA-rich fibers. Overall, we highlight the importance of molecular interactions and phase separation on the surface properties of fibers from lignin as an abundant raw material for the fabrication of new functional materials.Keywords
This publication has 27 references indexed in Scilit:
- Electrospinning: A Fascinating Method for the Preparation of Ultrathin FibersAngewandte Chemie International Edition, 2007
- A review on electrospinning design and nanofibre assembliesNanotechnology, 2006
- High flux ultrafiltration membranes based on electrospun nanofibrous PAN scaffolds and chitosan coatingPolymer, 2006
- Mechanical and structural characterization of electrospun PAN-derived carbon nanofibersCarbon, 2005
- Electrospinning of Nanofibers: Reinventing the Wheel?Advanced Materials, 2004
- Electrospun nanofibrous membranes coated quartz crystal microbalance as gas sensor for NH3 detectionSensors and Actuators B: Chemical, 2004
- Control of degradation rate and hydrophilicity in electrospun non-woven poly(d,l-lactide) nanofiber scaffolds for biomedical applicationsBiomaterials, 2003
- A review on polymer nanofibers by electrospinning and their applications in nanocompositesComposites Science and Technology, 2003
- Electrospun nanofibrous structure: A novel scaffold for tissue engineeringJournal of Biomedical Materials Research, 2002
- Nanometre diameter fibres of polymer, produced by electrospinningNanotechnology, 1996