Eraser-based eco-friendly fabrication of a skin-like large-area matrix of flexible carbon nanotube strain and pressure sensors
- 30 January 2017
- journal article
- Published by IOP Publishing in Nanotechnology
- Vol. 28 (9) , 095501
Abstract
This paper reports a new type of electronic, recoverable skin-like pressure and strain sensor, produced on a flexible, biodegradable pencil-eraser substrate and fabricated using a solvent-free, low-cost and energy efficient process. Multi-walled carbon nanotube (MWCNT) film, the strain sensing element, was patterned on pencil eraser with a rolling pin and a pre-compaction mechanical press. This induces high interfacial bonding between the MWCNTs and the eraser substrate, which enables the sensor to achieve recoverability under ambient conditions. The eraser serves as a substrate for strain sensing, as well as acting as a dielectric for capacitive pressure sensing, thereby eliminating the dielectric deposition step, which is crucial in capacitive-based pressure sensors. The strain sensing transduction mechanism is attributed to the tunneling effect, caused by the elastic behavior of the MWCNTs and the strong mechanical interlock between MWCNTs and the eraser substrate, which restricts slippage of MWCNTs on the eraser thereby minimizing hysteresis. The gauge factor of the strain sensor was calculated to be 2.4, which is comparable to and even better than most of the strain and pressure sensors fabricated with more complex designs and architectures. The sensitivity of the capacitive pressure sensor was found to be 0.135 MPa −1 .To demonstrate the applicability of the sensor as artificial electronic skin, the sensor was assembled on various parts of the human body and corresponding movements and touch sensation were monitored. The entire fabrication process is scalable and can be integrated into large areas to map spatial pressure distributions. This low-cost, easily scalable MWCNT pin-rolled eraser-based pressure and strain sensor has huge potential in applications such as artificial e-skin in flexible electronics and medical diagnostics, in particular in surgery as it provides high spatial resolution without a complex nanostructure architecture.Keywords
Funding Information
- Anusandhan National Research Foundation (YSS/2015/000863-SERB)
- Defence Research and Development Organisation (ERIP/ER/RIC/2015-16/10/M/01/1660)
This publication has 43 references indexed in Scilit:
- Graphene-based wearable temperature sensor and infrared photodetector on a flexible polyimide substrateFlexible and Printed Electronics, 2016
- Paper-Based Piezoelectric Touch Pads with Hydrothermally Grown Zinc Oxide NanowiresACS Applied Materials & Interfaces, 2014
- Highly Stretchable and Sensitive Strain Sensor Based on Silver Nanowire–Elastomer NanocompositeACS Nano, 2014
- A wearable and highly sensitive pressure sensor with ultrathin gold nanowiresNature Communications, 2014
- A Flexible and Highly Pressure‐Sensitive Graphene–Polyurethane Sponge Based on Fractured Microstructure DesignAdvanced Materials, 2013
- Extended symmetry transformation of (3+1)-dimensional generalized nonlinear Schrödinger equation with variable coefficientsChinese Physics B, 2013
- Flexible Piezoelectric ZnO–Paper Nanocomposite Strain SensorSmall, 2010
- Roadmap for 22nm and beyond (Invited Paper)Microelectronic Engineering, 2009
- A flexible strain sensor from polypyrrole-coated fabricsSynthetic Metals, 2005
- Nanotube film based on single-wall carbon nanotubes for strain sensingNanotechnology, 2004