Effective photodegradation of methomyl pesticide in concentrated solutions by novel enhancement of the photocatalytic activity of TiO2 using CdSO4 nanoparticles
- 6 August 2013
- journal article
- research article
- Published by Springer Nature in Environmental Science and Pollution Research
- Vol. 21 (2) , 1425-1435
Abstract
Annihilation of electrons–holes recombination process is the main remedy to enhance the photocatalytic activity of the semiconductors photocatalysts. Doping of this class of photocatalysts by foreign nanoparticles is usually utilized to create high Schottky barrier that facilitates electron capture. In the literature, because nonpolar nanoparticles (usually pristine metals, e.g., Ag, Pt, Au, etc.) were utilized in the doping process, the corresponding improvement was relatively low. In this study, CdSO4-doped TiO2 nanoparticles are introduced as a powerful and reusable photocatalyst for the photocatalytic degradation of methomyl pesticide in concentrated aqueous solutions. The utilized CdSO4 nanoparticles form polar grains in the TiO2 matrix due to the electrons leaving characteristic of the sulfate anion. The introduced nanoparticles could successfully eliminate the harmful pesticide under the sunlight radiation within a very short time (less than 1 h), with a removal capacity reaching 1,000 mg pesticide per gram of the introduced photocatalyst. Moreover, increase in the initial concentration of the methomyl did not affect the photocatalytic performance; typically 300, 500, 1,000, and 2,000 mg/l solutions were completely treated within 30, 30, 40, and 60 min, respectively, using 100 mg catalyst. Interestingly, the photocatalytic efficiency was not affected upon multiple use of the photocatalyst. Moreover, negative activation energy was obtained which reveals super activity of the introduced photocatalyst. The distinct photocatalytic activity indicates the complete annihilation of the electrons–holes recombination process and abundant existence of electrons on the catalyst surfaces due to strong electrons capturing the operation of the utilized polar CdSO4 nanoparticles. The introduced photocatalyst has been prepared using the sol–gel technique. Overall, the simplicity of the synthesizing procedure and the obtained featured photocatalytic activity strongly recommend the introduced nanoparticles to treat the methomyl-containing polluted water.Keywords
This publication has 30 references indexed in Scilit:
- Nematic shaped cadmium sulfide doped electrospun nanofiber mat: Highly efficient, reusable, solar light photocatalystColloids and Surfaces A: Physicochemical and Engineering Aspects, 2012
- Adsorption behavior of pesticide methomyl on activated carbon in a high gravity rotating packed bed reactorWater Research, 2012
- Titanium-based polymeric electrospun nanofiber mats as a novel organic semiconductorMaterials Science and Engineering: B, 2012
- Cu-doped TiO2 nanoparticles for photocatalytic disinfection of bacteria under visible lightJournal of Colloid and Interface Science, 2010
- Functionalization of Electrospun Titanium Oxide Nanofibers with Silver Nanoparticles: Strongly Effective PhotocatalystInternational Journal of Applied Ceramic Technology, 2010
- Adsorptive removal of the pesticide methomyl using hypercrosslinked polymersJournal of Hazardous Materials, 2008
- Residue analysis of 500 high priority pesticides: Better by GC–MS or LC–MS/MS?Mass Spectrometry Reviews, 2006
- Removal of pesticide residues in water using the nanofiltration processDesalination, 2000
- Effects of natural organic matter and the raw water matrix on the rejection of atrazine by pressure-driven membranesWater Research, 1998
- The interaction of some pesticides and herbicides with humic substancesAnalytica Chimica Acta, 1996