Exergy, Economic and Environmental Analyses of Gas Turbine Inlet Air Cooling with a Heat Pump Using a Novel System Configuration
Open Access
- 22 October 2015
- journal article
- research article
- Published by MDPI AG in Sustainability
- Vol. 7 (10) , 14259-14286
Abstract
Gas turbines incur a loss of output power during hot seasons due to high ambient air temperatures, and input air cooling systems are often used to partly offset this problem. Here, results are reported for an investigation of the utilization of a heat pump to cool the inlet air of a gas turbine compressor. The analyses are carried out for two climates: the city of Yazd, Iran, which has a hot, arid climate, and Tehran, Iran, which has a temperate climate. The heat pump input power is obtained from the gas turbine. The following parameters are determined, with and without the heat pump: net output power, first and second law efficiencies, quantities and costs of environmental pollutants, entropy generation and power generation. The results suggest that, by using the air-inlet cooling system, the mean output power increases during hot seasons by 11.5% and 10% for Yazd and Tehran, respectively, and that the costs of power generation (including pollution costs) decrease by 11% and 10% for Yazd and Tehran, respectively. Also, the rate of generation of pollutants such as NOx and CO decrease by about 10% for Yazd and 35% for Tehran, while the average annual entropy generation rate increases by 9% for Yazd and 7% for Tehran, through air-inlet cooling. The average increase of the system first law efficiency is 2% and of the system second law efficiency is 1.5% with the inlet-air cooling system.Keywords
This publication has 20 references indexed in Scilit:
- Exergy, economic and environment (3E) analysis of absorption chiller inlet air cooler used in gas turbine power plantsInternational Journal of Energy Research, 2011
- Effect of various inlet air cooling methods on gas turbine performanceEnergy, 2011
- Sensitivity analysis for the capacity improvement of a combined cycle power plant (100–600MW)Applied Thermal Engineering, 2008
- Comparison of evaporative inlet air cooling systems to enhance the gas turbine generated powerInternational Journal of Energy Research, 2007
- Performance improvement of the combined cycle power plant by intake air cooling using an absorption chillerEnergy, 2006
- Thermodynamic assessment of power requirements and impact of different gas-turbine inlet air cooling techniques at two different locations in OmanApplied Thermal Engineering, 2005
- Performance and economic of the thermal energy storage systems to enhance the peaking capacity of the gas turbinesApplied Thermal Engineering, 2005
- The study of capacity enhancement of the Chabahar gas turbine installation using an absorption chillerApplied Thermal Engineering, 2004
- Integration of steam injection and inlet air cooling for a gas turbine generation systemEnergy Conversion and Management, 2004
- Enhancing gas turbine performance by intake air cooling using an absorption chillerHeat Recovery Systems and CHP, 1995