Using GOOSE Messages in a Main–Tie–Main Scheme
Authors:
Open Access
- 6 June 2013
- journal article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Industry Applications
- Vol. 50 (1) , 17-24
Abstract
Main-tie-main (MTM) transfer schemes increase reliability in a power system by switching a load bus to a secondary power source when power interruption occurs on the primary source. Traditionally, the large number of physical I/O lines required makes MTM schemes expensive to design and implement. Using Ethernet-based IEC 61850, these hardwired I/O lines can be removed and replaced with generic object-oriented substation event (GOOSE) messages. Adjustment of the scheme for optimal performance is done via software that saves redesign and rewiring times. Special attention is paid to change-of-state GOOSE only; no analog GOOSE messages are used, making the scheme fast and easy to configure, maintain, and troubleshoot. Applications such as fast motor-bus transfer are discussed with synchronization remaining at each breaker relay. Simulation test results recorded GOOSE message latencies on a system configured for an MTM scheme. This paper presents the details of open and closed manual and automatic transfers.Keywords
This publication has 4 references indexed in Scilit:
- Transfer time measurement for protection relay applications with the IEC 61850 standard2010
- Design of a High-Speed Motor Bus Transfer SystemIEEE Transactions on Industry Applications, 2010
- Automated bus transfer control for critical industrial processesIEEE Transactions on Industry Applications, 1991
- Analysis of Transient Electrical Torques and Shaft Torques in Induction Motors as a Result of Power Supply DisturbancesIEEE Power Engineering Review, 1982