Dead time optimization through loss analysis of an active-clamp flyback converter utilizing GaN devices
Authors:
- 1 September 2012
- conference paper
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- No. 23293721,p. 3882-3889
Abstract
This paper presents an analysis of losses that occur during dead time in an active-clamp flyback converter utilizing Gallium Nitride based MOSFETs. This analysis is used to optimize the length of the dead-time period in order to minimize losses in the switching devices. When compared to silicon-based MOSFETs, GaN-based MOSFETs have lower switching losses and much higher reverse conduction losses, so it is not desirable to design for zero-voltage switching (ZVS) over a wide load range. The analysis presented in this paper finds an optimal trade-off between partial ZVS and reverse conduction losses, minimizing overall device switching losses and therefore increasing converter efficiency over the desired load range. A 15-W, four-output active-clamp flyback converter utilizing GaN devices at 1 MHz is designed and implemented using the recommended optimization. The experimental results confirm this analysis and result in a minimization of switching losses and an increase in converter efficiency.Keywords
This publication has 21 references indexed in Scilit:
- Digitally controlled active clamp interleaved flyback converters for improving efficiency in photovoltaic grid-connected micro-inverter2012
- 1 MHz cascaded Z-source inverters for scalable grid-interactive photovoltaic (PV) applications using GaN device2011
- A gallium-nitride switched-capacitor circuit using synchronous rectification2011
- High Step-Up Ratio Flyback Converter With Active Clamp and Voltage MultiplierIEEE Transactions on Power Electronics, 2011
- A High Efficiency Flyback Converter With New Active Clamp TechniqueIEEE Transactions on Power Electronics, 2010
- Reduced-order averaged modeling of active-clamp convertersIEEE Transactions on Power Electronics, 2006
- Zero voltage switching approach for flyback converter2003
- Modeling of an active clamp discontinuous conduction mode flyback converter under variation of operating conditions1999
- Characterization of an active clamp flyback topology for power factor correction applicationsIEEE Transactions on Power Electronics, 1996
- Utilization of an active-clamp circuit to achieve soft switching in flyback convertersIEEE Transactions on Power Electronics, 1996