Influence of different drying methods on microtensile bond strength of self-adhesive resin cements to dentin
Authors:
- 12 June 2014
- journal article
- Published by Medical Journals Sweden AB in Acta Odontologica Scandinavica
- Vol. 72 (8) , 954-962
Abstract
Objective. This study investigated the effect of different drying methods of dentin surface on the bonding efficacy of self-adhesive resin cements (SRCs). Materials and methods. Three SRCs (RelyX U200, RU; Maxcem Elite, ME; and BisCem, BC) and one resin-modified glass ionomer cement (RelyX Luting 2, RL) were used. The characteristics of the materials were evaluated using thermogravimetric analysis and surface roughness and contact angle measurements. Human dentin surfaces were finished with 600-grit silicon carbide paper and assigned to three groups according to these drying methods: ethanol dehydration, drying by waiting for 10 s after blot-drying and blot-drying. The four cements were used for luting composite overlays to the dried dentin. After 24 h storage at 37°C and 100% relative humidity, stick-shaped specimens with a cross-sectional area of 0.8 mm2 were prepared and stressed to failure in tension at a crosshead speed of 0.5 mm/min (n = 27). Failure modes of fractured specimens were assessed by optical and scanning electron microscopy. Results. RL was the most hydrophilic, followed by BC and ME and then RU. All the luting cements luted to ethanol-dehydrated dentin showed zero bond strengths. For the three SRCs, drying by waiting produced higher microtensile bond strengths than blot-drying. RU showed the best bonding performance in the above two dentin conditions. RL showed significantly higher bond strength in blot-drying condition than in drying-by-waiting (p < 0.001). Conclusions. This study suggests that dentin surface moisture has a crucial effect on the bond strength of SRCs.Keywords
This publication has 29 references indexed in Scilit:
- Influence of surface energy parameters of dental self-adhesive resin cements on bond strength to dentinJournal of Adhesion Science and Technology, 2013
- Effectiveness of self-adhesive luting cements in bonding to chlorhexidine-treated dentinDental Materials, 2012
- 'Wet or Dry tooth surface?' - for self-adhesive resin cementRestorative Dentistry & Endodontics, 2012
- Adhesion/cementation to zirconia and other non-silicate ceramics: Where are we now?Dental Materials, 2011
- Self-adhesive resin cements - chemistry, properties and clinical considerationsJournal of Oral Rehabilitation, 2010
- Luting glass ceramic restorations using a self-adhesive resin cement under different dentin conditionsJournal of Applied Oral Science, 2010
- Effect of pulpal pressure on the microtensile bond strength of luting resin cements to human dentinDental Materials, 2009
- Dental cements: formulations and handling techniques2008
- Flexural Strength, Elastic Modulus, and pH Profile of Self‐etch Resin Luting CementsJournal of Prosthodontics, 2007
- Bonding of an auto-adhesive luting material to enamel and dentinDental Materials, 2004