Aquifer Management To Accelerate CO2 Dissolution and Trapping
Authors:
- 1 June 2012
- journal article
- Published by Society of Petroleum Engineers (SPE) in SPE Journal
- Vol. 17 (03) , 805-816
Abstract
Summary: Bulk-phase CO2 injection into saline aquifers can provide substantive reduction in CO2 emissions if the risk arising from aquifer pressurization is addressed adequately through mechanisms such as brine production out of the system (Anchliya 2009). While this approach addresses the risks associated with aquifer pressurization it does not address the problem of ensuring CO2 trapping as an immobile phase and its accumulation at the top of the aquifer. The performance of bulk-CO2-injection schemes highly depends on the seal-integrity assessment and presence of thief zones. The accumulated pocket of free CO2 can readily leak through a breach in the aquifer seal. Ideally, the aquifer should be monitored as long as the free CO2 is present, but if the CO2 is not immobilized, it is expected to remain underneath the seal rock for more than 1,000 years. Therefore, long-term monitoring of the seal integrity and avoiding leakage will be very costly. To minimize the free CO2 below the caprock, we propose an engineered system to reduce aquifer pressurization and accelerate CO2 dissolution and trapping. We achieve these objectives through effective placement of brine injection and production wells to facilitate the lateral movement (hence, residual and solubility trapping) of CO2 in the aquifer and impede its upward movement. The simulation results for example engineered well configurations in this paper suggest that substantial improvements in immobilizing CO2 can be achieved through increasing enhanced solubility and residual trapping that result from better CO2-injection sweep efficiency. This approach has the potential to greatly reduce the risk of CO2 leakage both during and after injection. The controlled injection of CO2 with this technique reduces the uncertainty about the long-term fate of the injected CO2, prevents CO2 from migrating toward potential outlets or sensitive areas, and increases the volume of CO2 that can be stored in a closed aquifer volume during the CO2-injection period. Field-scale compositional simulation cases are discussed, and sensitivity studies are used to provide guidelines for well spacing and flow rates depending on aquifer properties and the volume of CO2 to be stored. Although it requires additional drilled wells, the active engineered configuration proposed for CO2 injection significantly reduces the reservoir volume required to effectively sequester a given volume of CO2, and the increase in the cost caused by additional wells is recovered by dramatic reduction in monitoring cost.Keywords
This publication has 12 references indexed in Scilit:
- Optimization of Residual Gas and Solubility Trapping for CO2 Storage in Saline Aquifers2009
- Applied Geostatistics with SGeMS2009
- Time-Dependent Injectivity During CO2 Storage in Aquifers2008
- Eliminating Buoyant Migration of Sequestered CO2 Through Surface Dissolution: Implementation Costs and Technical Challenges2007
- Scaling Analysis of the Migration of CO2 in Saline Aquifers2006
- Relative Permeability Hysteresis: Trapping Models and Application to Geological CO2 Sequestration2005
- Water to Value - Produced Water Management for Sustainable Field Development of Mature and Green FieldsJournal of Petroleum Technology, 2003
- Engineering Aspects of Geological Sequestration of Carbon Dioxide2002
- Residual Gas Saturation to Aquifer Influx: A Calculation Method for 3-D Computer Reservoir Model Construction2002
- Disposal of carbon dioxide in permeable underground layers: A feasible option?Climatic Change, 1993