Investigation of gap-closing interdigitated capacitors for electrostatic vibration energy harvesting
Open Access
- 14 September 2015
- journal article
- Published by IOP Publishing in Journal of Micromechanics and Microengineering
- Vol. 25 (10) , 105010
Abstract
This paper reports on the dynamic characteristics of a MEMS electrostatic harvester employing interdigitated gap-closing topology. Devices are fabricated using SOIMUMPS technology and are characterized with and without biasing voltages for a broad range of excitation accelerations. At low vibration amplitudes the presence of a dc bias causes the resonant frequency peak to shift to lower frequencies with increasing bias. At higher vibration amplitudes the dynamic response of the devices exhibits the behavior of a Duffing oscillator with spring softening due to nonlinear stiffness attributed to the effect of electrostatic forces. Specifically, the devices exhibit sweep direction hysteresis with jump phenomena due to the multivaluedness of the response curve. Amplitude sweeps at constant frequency and varying bias voltage also show jump phenomena, highlighting how slight differences in operating conditions dramatically affect device performance. Spring hardening effects are reported for devices contaminated with dust particles. The paper also discusses SOIMUMPS limitations, the importance of reducing off-axis vibration during testing, characterization methods, and the effect of grounding on parasitic capacitance.Keywords
Funding Information
- New York State Energy Research and Development Authority (34934)
- National Science Foundation (0925733)
This publication has 35 references indexed in Scilit:
- Electrostatic vibration energy harvester with combined effect of electrical nonlinearities and mechanical impactJournal of Micromechanics and Microengineering, 2014
- Fundamental issues in nonlinear wideband-vibration energy harvestingPhysical Review E, 2013
- Microscale electrostatic energy harvester using internal impactsJournal of Intelligent Material Systems and Structures, 2012
- Analysis and characterization of triangular electrode structures for electrostatic energy harvestingJournal of Micromechanics and Microengineering, 2011
- Modeling and experimental verification of low-frequency MEMS energy harvesting from ambient vibrationsJournal of Micromechanics and Microengineering, 2011
- A batch-fabricated and electret-free silicon electrostatic vibration energy harvesterJournal of Micromechanics and Microengineering, 2009
- Fabrication, characterization and modelling of electrostatic micro-generatorsJournal of Micromechanics and Microengineering, 2009
- Theoretical comparison of the energy harvesting capability among various electrostatic mechanisms from structure aspectSensors and Actuators A: Physical, 2009
- A capacitive vibration-to-electricity energy converter with integrated mechanical switchesJournal of Micromechanics and Microengineering, 2008
- A study of low level vibrations as a power source for wireless sensor nodesComputer Communications, 2003